7G(A Complete Start Guide)GETTING STARTED (A Complete Start Guide)8ETTING STARTED
Installing Windows XP Service Pack 1
DesXcape runs on Microsoft Windows XP Professional Edition with Service Pack 1. If you have not
yet installed Windows XP Service Pack 1 (or higher) on your computer, please follow this step. If
you already have most recent Windows XP Service Pack installed on your computer, please skip this
step and go to the next Hardware Setup section.
To check if you have Windows XP Service Pack 1
installed, right-click on My Computer, choose
Properties, General. If you do not see Service Pack1
information is displayed, you do not have ServiceDVI-D
Pack installed.2
To install Windows XP Service Pack 11
1 Put the Windows XP Service Pack 1 CD into CD-2
ROM driveVGA
3
2 Run XPSP1.exe from CD-ROM drive and
Service Pack 1 is automatically installed.
Alternative:Open the Start menu.Choose My Computerand dou-
Load Battery
ble-click on XPSP1.exeicon on your CD-ROM drive.
If you experience problems with any of your existing applica-Service1 Make sure the power switch of your DesXcape
Pack1
tion after the Microsoft Windows XP Service Pack 1 is150DM is in the power-off position.
3
installed, please go to the Microsoft website for additional2 Install the battery into DesXcape 150DM,
2
information or contact your application provders.and you will see the startup screen for a
power
few seconds before it goes off.off1
Hardware Setup
Cable Setup
In this section, you will set up the initial hardware environment for your DesXcape 150DM.
1 Connect the power cord to the AC power adaptor, plug it into the base station and then into a
power outlet.
2 If you plan to use DesXcape 150DM as your desktop monitor, make sure your computer is run-Get Ready
ning a resolution of 1024 x 768 or lower. Plug the VGA cable into the base station and
then into your computer.1 Place DesXcape 150DM on the base station
To check and adjust the resolution of your computer,right-click on your Windows Desktop.Screen Resolution is locat-2 Power on your computer
ed under Properties,Settings.For additional information about your computerOs resolution,please contact your3 Power on DesXcape 150DM
computer vendor.
For users with DVI-D video interface, instead of using the included VGA cable, plug your own
Additional Hardware Setup
DVI-D cable to the DVI-D port on the base station.
3 If you want to use the audio output on your base station for speakers or a headset, plug theDuring the setup process, on screen prompts
included audio cable into the audio in port on your base station, and then into the audiowill let you know when it is time to installpower
on
out port on your computer.additional hardware. |