POWER ON
Select STANDARD, STANDBY or FORCED mode. The different modes are as explained below:
STANDARD: TV will be automatically switched to the last status (STANBY or ON)
whenever the mains power is turned ON or resumed after a power interruption.
STANDBY: TV will be automatically switched to STANBY(even if the last status was ON)
whenever the mains power is turned ON or resumed after a power interruption.
FORCED: TV will be automatically switched to ON whenever the mains power is turned ON
or resumed after a power interruption. Note that the remote control STANDBY key will no
longer function when TV is set to this mode.
LNA (LOW NOISE AMPLIFIER)
Select OFF, ON or AUTO. If ON is selected, the LNA feature in the TV set will always be
applied to incoming signals. If set to AUTO, the TV set will first analyze incoming signals and
apply the LNA feature if necessary. By default, the LNA setting is OFF.
STEP TUNING
For calling up or changing channels. When this feature is switched YES, the TV will respond
immediately to the change of channel upon keying in the first digit. If this feature is switched
NO, one has to either wait for a few seconds after keying in the first digit or complete keying in
2 digits before TV changes channel.
Note: When an external set-top box is connected to the RJ12 port for IR link, choose either
YES/NO for optimum channel switching performance.
DIGIT TIMEOUT
Selects the digit entry timeout period via digit key entry from 1.0 SEC to 9.9 SEC. This allows
the response time between the 1st digit entry and the 2nd digit entry to be adjusted when
2-digit entry is needed.
BLANKING TIME
Sets the blanking interval between the switching of channels. The recommended default setting
is 900 to 960ms.
CHANNEL DISPLAY
Selects the ways of displaying the information for a channel. The options are: ALL (display the
number and label of a channel), NONE (do not display any information), NUMBER (display
only the number of a channel) and LABEL (display only the label of a channel).
KEYBOARD LOCK
To lock TV control keys, select YES. To unlock, select NO.
FREE PROTECTED
Remove PROTECTION features for all channels set under TV SETUP menu. All channels
are not protected when select YES.
ESP (ENERGY SAVING PROGRAMMABLE)
This feature selects a time when the TV will automatically turn off. The TV must remain on
continuously during the period of time you select. If the power is switched off, the ESP timer will
be re-initialised. Highlight ESP, then key in the required time with the digit keys. Select 0 if you do
not wish to use this feature. If sleeptimer is selected, it would have priority over ESP time.
15
p13-19152/4/05, 12:19 PM |
ACEC
PHILIPS
