Channel tuning
Available channels:
- Cable (analog NTSC or digital QAM)
- Terrestrial (analog NTSC or digital ATSC)
If a tuned channel is not yet in the master channel map, the TV
will attempt to tune to the channel and it will be added to the
map.
If the channel is not acquired, a message will appear reporting
that the channel is not available. When you tune an audio-only
digital subchannel, a display appears with the message Audio only.
Note: Subchannel selections
The new standards employed with digital broadcasting make it possible
to receive multiple program channels under a single major channel
Note: Digital Channel selection delaynumber which can be selected by pressing the digit remote control
Due to the tuning complexity of subchadnneirel ct-access channel number entry.
digital programming, the time to select and view
a digital channel may take slightly longer than
Important:
what the viewer is normally accustomed to (as
After the installation of the TV channels is completed, always
compared to analog channel programs).
make a selection in the Installation menu between Antenna or
Digital channel broadcasts contain program and
Cable whether you want to watch Antenna TV channels or Cable
system data information that must be processed
TV channels.
before the channel selection can be displayed.
If you make use of a signal splitter do not forget to put the switch
in the corresponding position.
Weak channel installation
SettingsAntenna reception for broadcast channels may vary. If you are
InstallationWeak channel installationhaving difA culties acquiring weaker signals, we suggest you use:
Language2
Weak Signal Installation feature.
Autoprogram3
Here?s how:
Source4
Clock5
1In the antenna mode, select a channel from the displayed list of
Weak channel installation6
TV channels. Select the Start by pressing red button on the
Current software info7
Reset AV settings8remote control; TV set will detect the signal.
92The signal strength is continuously displayed and updated as you
Info
rotate the antenna.
When strength is enough to identify, user can store the
channel in the channel list by pressing green button on the
remote control.
Settings
InstallationCurrent software info
Current software info
LanguageFXXXXXXXXX CPT Demo
AutoprogramThis menu will appear with your TV software information.
Source
Clock
1Press the MENU button on the remote control.
Weak channel installation
2
Current software infoUse the cursor down to select Installation in the Settings menu.
Reset AV settings3Using the cursor up/down to choose Current software info
the TV software information is displayed.
Info
13 |