TV menu-Install
Select the menu language
Main Controls1Press the MENU button on the remote control.
Install5Language2
2Use the cursor down to select Install in the Settings menu.
LanguageEnglish
3Use the cursor right to enter the Install menu.
Auto store?�
Manual store4Select Language and enter the list of available languages with the
Channel settingcursor right.
Factory reset
5Select your preferred language with the cursor up/down and press
the OK button to con� rm your selection.
6Proceed with the Install menu.
Info
Main ControlsStore TV channels
Install5Auto store
1Press the MENU button on the remote control.
Language
Auto storeStart ?2Use the cursor down to select Install in the Settings menu.
Manual store3Use the cursor right to enter the Install menu.
Channel setting4Press cursor down to select Auto store in the Install menu.
Factory reset
5Use the cursor right to enter the Auto store m enu and press OK
to start scanning of channels.
Info
Auto store
Please wait
Prog. found 0Auto storing may take up to 3 minutes to complete. Please wait
Frequency 246.50 MHzuntil Auto storing is completed . The TV will then switch
automatically to the rst channel found.
Notes:
Immediately after unpacking and plugging in your new television, run the auto store function to set up the TV for the broadcast or
cable channels available in your area. If you do not run the auto store function to set up the channels, your television may not
operate properly.
After you?ve run Auto store, check out the results. Press P (+) or the P (-) button and see which channels you can select.
Remember, an antenna or cable TV signal must rst be connected to your LCD TV.
10 |