SAFETY ADVICES BEFORE USING THE
DRYER / CONNECTIONS
1. Removing the packaging and checkStability:
? After unpacking, make sure that the dryer is When installing the dryer always carefully level the
undamaged. If in doubt, do not use the dryer. dryer adjusting the four feet and check the correct
Contact After-Sales Service or your local retailer.levelling with a spirit level.
Keep the packaging materials (plastic bags, To built in the dryer
polystyrene parts, etc.) out of reach of children, as Remove the work-top and replace it with the Built-
they are potentially dangerous.In Kit (according to Eec Electrical Regulations),
Remove the protective foil from the control panel.available at your dealer. As prescribed by law, only
a qualified technician has to do the installation.
2. Electrical Connections
Electrical connections must be carried out by a Stacking kit
qualified technician in compliance with the Your dryer can be stacked on top of your front
manufacturer's instructions and current standard loading washing machine. The type of stacking kit is
safety regulations.stated in the Instruction for use of your washing
Electrical connection must comply with local machine or pls. contact your dealer or our After
Sales Service.
Electricity Board regulations.
Voltage information, power consumption and the Minimum housing dimensions:
required fuse protection is shown on the rating Width:600 mm
plate mounted at the rear of the dryer.Height:855 mm
The manufacturer cannot accept any liability for Depth:600 mm
personal injury or damage to property resulting
from failure to adhere to these instructions.
The dryer must be earthed as prescribed by law.
Do not use extension leads or multiple adaptors.
Before any maintenance on the dryer disconnect it
from the mains supply.
Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales
Service technicians.
Mains cable replacement is only to be carried out by
After-Sales Service.
After installation access to the mains plug has to be
guaranteed, or the all-pole disconnection has to be
possible with a switch.
3. Installation
Do not install your dryer where it can be subject to
extreme conditions, such as: poor ventilation,
temperatures around freezing or above 35° C.
Before running the first cycle ensure the water
container and heat exchanger are correctly
positioned.
Only for water container top version: if possible use
a hose to drain the water directly into the domestic
plumbing system. This will avoid having to empty
the water container at the end of each drying cycle
since the condensation water can be directly
drained away. See also chapter ?Drainage System?.
Take care not to install the dryer on a deep-pile
carpet.
Take care not to trap the mains cable between the
dryer and the wall.
21 |