Y Never recharge the batteries, apply heat to them or
Power supplytake them apart.
Y Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to
remove.
OPR/BATT
STANDBY
Connections
IMPORTANT
The OPR/BATT 6STANDBY indicator lights up whileY Make sure that the AC cord is disconnected and
the power is on or the AC cord is connected to an ACbatteries are removed before connecting speakers.
outlet.Y Do not connect other than the supplied speakers.
1Position the speakers.
Using on AC house currentTo couple with the speakers, slide each speaker
down into the guide brackets on the center unit until
Connect the AC cord as illustrated below.the height is level with the unit.
To separate the unit from the speakers, slide the
speakers up and off, while pressing the speaker
release knob.
to the AC inlet of the unit
supplied AC cordto an AC outlet
(AC 220-240 V,
50/60 Hz)
CAUTION
Use only the supplied AC cord. Use with other cords
may result in the risk of fire.
Release knob
Using on batteries2Connect the speakers.
Connect the right speaker cord to the R terminals,
Open the lid of the battery compartment on the rear andand the left speaker to the L terminals.
insert eight R20 (size D) batteries, not supplied, asConnect the speaker cord with the white broken line
illustrated below. Then close the lid.to 0 and the other cord to 9.
To switch from AC power supply to battery supply,
disconnect the AC cord from the AC inlet.
R20 (D)
When the OPR/BATT 6STANDBY indicator becomes
dim, the tape speed slows down, volume decreases, or
sound is distorted during operation, replace the
batteries.
Notes on batteries
To avoid damage from leakage or explosion, observe
the following:
Y Insert the batteries with the 0 and 9 marks correctly
aligned.
Y Do not mix different types of batteries or old batteries
with new ones.
Y When the unit is not to be used for a long period,
remove the batteries.
4 ENGLISH |