WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRICPrecautions
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
Read the Operating Instructions carefully and
RAIN OR MOISTURE.
completely before operating the unit. Be sure to keep
the Operating Instructions for future reference. All
warnings and cautions in the Operating Instructions and
CAUTION
on the unit should be strictly followed, as well as the
RISK OF ELECTRIC SHOCK
DO NOT OPENsafety suggestions below.
OCAUTION:TO REDUCE THE RISK OF
Installation
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).1 Water and moisture - Do not use this unit near
NO USER-SERVICEABLE PARTS INSIDE.water, such as near a bathtub, washbowl, kitchen
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.�sink, laundry tub, in a wet basement, swimming pool,
or the like.
2 Heat - Do not use this unit near sources of heat,
including heating vents, stoves, or other appliances
Explanation of Graphical Symbols:
that generate heat.
The lightning flash with arrowhead symbol,It also should not be placed in temperatures less
within an equilateral triangle, is intendedthan 5!C (41!F) or greater than 35!C (95!F).
to alert the user to the presence of3 Mounting surface - Place the unit on a flat, even
uninsulated Odangerous voltage� within thesurface.
productOs enclosure that may be of4 Ventilation - The unit should be situated with
sufficient magnitude to constitute a risk ofadequate space around it so that proper heat
electric shock to persons.ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the
The exclamation point within antop of the unit and 5 cm (2 in.) from each side.
equilateral triangle is intended to alert the- Do not place the unit on a bed, rug, or similar
user to the presence of importantsurface that may block the ventilation openings.
operating and maintenance (servicing)- Do not install the unit in a bookcase, cabinet, or
instructions in the literature accompanyingairtight rack where ventilation may be impeded.
the appliance.5 Objects and liquid entry - Take care that objects or
liquids do not get inside the unit through the
ventilation openings.
OWNEROS RECORD
6 Carts and stands - When placed or
For your convenience, record the model number (you
mounted on a stand or cart, the unit
will find it on the rear of the unit) and serial number (youshould be moved with care.
will find it in the battery compartment) in the spaceQuick stops, excessive force, and
provided below. Please refer to them when you contact
uneven surfaces may cause the unit
your AIWA dealer in case of difficulty.or cart to overturn or fall.
7 Condensation - Moisture may form on the CD
Model No.
pickup lens when:
- The unit is moved from a cold spot to a warm spot
Serial No.- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not
function normally. Should this occur, leave the unit
for a few hours, then try to operate again.
8 Wall or ceiling mounting - The unit should not be
mounted on a wall or ceiling, unless specified in the
Operating Instructions.
Electric Power
1 Power sources - Use on batteries or AC house
current, as specified in the Operating Instructions
and marked on the unit.
2 Polarization - As a safety feature, some units are
equipped with polarized AC power plugs which can
only be inserted one way into a power outlet. If it is
difficult or impossible to insert the AC power plug
into an outlet, turn the plug over and try again. If it
still does not easily insert into the outlet, please call
a qualified service technician to service or replace
2 ENGLISH |
ACEC
AIWA
