HELPFUL INFORMATIONENERGY SAVING AND OPERATION
Auto Operation Button Auto Restart ControlHINTS
Y If power is resumed after a power failure, the Setting the Temperature
operation will restart automatically after 3 - 5 1/2
minutes.Y Approximately 10% of electricity can be saved.
Y Set the temperature 2!F higher than the desired
ECONOMYECONOMYECONOMYECONOMYPOPOPOPOWERFULWERFULWERFULWERFULPOPOPOPOWERWERWERWER SLEEPSLEEPSLEEPSLEEP TIMERTIMERTIMERTIMERY Operation will be restarted automatically under thetemperature.
previous operation mode and airflow direction when
power is resumed as the operation is not stoppedY Raise the front panel and press.
by the remote control. Air Filters and Air Purifying Filters
Y Clean the air filters every 2 weeks and the Air
Purifying Filters every 6 months.
Timer SettingY Dirty filters may reduces cooling efficiency.
Automatic OperationY When power failure occurs, the timer setting will be
cancelled. Once power is resumed, reset the timer.
Y If the remote control fails to function or has been Keep All Doors and Windows Closed
misplaced, press the Auto Operation button to startY Otherwise, cooling performance will be reduced
the Automatic operation. Thunder and Lightningand electricity cost is wasted.
Y The Automatic operation will be activatedY This air conditioner is equipped with a built-in surge
protective device. However, in order to further
immediately once the Auto operation button isprotect your air conditioner from being damaged by Outdoor Unit
pressed. However, temperature cannot be adjustedY Do not block the air outlet vents. Otherwise, it will
in this operation.abnormally strong lightning activity, you may switchlower the cooling performance.
Y The power indicator on the indoor unit will blink untiloff the main power supply and unplug from power
socket.
the operation mode is selected automatically. Timer and Sleep Mode
Y To cancel this operation, press once more.Y To prevent wastage of electricity, use sleep mode
when sleeping or Timer when going out.
Remote Control Signal Receiving Sound
Y To switch off the beep (Signal Receiving Sound), Avoid Direct Sunlight
press the Auto Operation button for 10 secondsY Keep curtains or drapes closed to avoid direct
continuously or longer.sunlight during cooling operation.
OBeep�, Obeep� sound will be heard at the tenth
seconds.
Note: OBeep� sound will be heard at the fifth
seconds;
However please press continuously until you
heard Obeep�, Obeep� sound.
Y Repeat the above steps if you want to switch on the
Signal Receiving Sound.
(This is for Servicing purposes only.)
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed. A
Obeep� sound will be heard at the fifth seconds
indicating the Test Run starts to operate.
9 |