TROUBLESHOOTING GUIDE
This appliance is equipped with safety Detergent and additive functions product residues
which detect faults at an early stage anin dispenser at end of wash.d react
appropriately.Check whether:
Often, however, the faults detected are smal the siphl on is correctly installed and clean
enough to be solved in a matter of minutes.(see ?Maintenance and Cleaning?/
The appliance will not start, no lamp ?Dispenser Cleaning Instructions?);
enough water is being supplied. The mesh
lights up.filters could be clogge?Maind (see tenance
Check whether:and Cleaning?/?Water Hose Mesh Filte?).rs
the appliance is plugged in;
The appliance vibrates during the spin
the wall socket is functioning correctly (use a
table lamp or similar).cycle.
Check whether:
The appliance will not start, but the pilot
the appliance is level and solidly installed on
light is on.all feet (s?Installationee instruc?); tions
Check whether: the transport screws and transport bar have
the appliance lid is properly closed;been removed. Before starting up the
a programme has been selected;appliance, the transport screws and the
the programme is started;transport bracket must be removed
the water tap is open.(see ?Installation instructions?).
The appliance stops during the Final spin results are poor.
programme. the appliance has an imbalance detection and
Check whether:correction system. If individual heavy articles
the ?Rinse Hold? button is pressed: terminate are loaded (bathmat, bathrobe, etc.) this
this option;system may reduce the spin speed
the water tap is open;automatically to protect the appliance. It may
the pump / foreign body trap are blocked (see even interrupt the spin cycle altogether, if the
?Removing the Foreign Body? Tra); pimbalance is too great after several spin starts;
if the laundry is too humid at the end of the
the Water stop could be activated (see
?Water stop fa?).ultcycle, add more articles of laundry to balance
the load and repeat the spin cycle;
Insufficient or no water supply. excessive foam formation may prevent
Check whether:spinning. Use less detergent.
the water tap is completely open, and the Check whether:
water supply pressure is sufficient; the pump impeller is obstructed (see
the water inlet hose is kinked;?Removing the Foreign Body Trap?);
the mesh filters are clogged (see the lid was opened during the delicate or
?Maintenance and Cleaning?/?Water Hose wool programme. Close the lid and select a
Mesh Filters?);spin programme.
the water inlet hose is frozen.Water stop fault (depending on model).
Reselect the desired programme and start aga The in Water stop can be released by:
to continue with the programme (do not add1. too much foam;
detergent for this programme).2. a leak in the water hose or appliance.
The appliance does not drain out the watCloer.se the tap, switch off the appliance and
Check whether:unplug it.
drain hose is kinked (see ?Installation Evacuate water from the bottom tray by tilting
Instructions?);the appliance to the front.
the pump/ foreign body trap are blocThked (see en:
?Removing the Foreign Body? Tra); p Turn on the tap, plug in the appliance to the
IMPORTANT: Before draining, allow the wash electrical outlet and start again.
water to cool down.The programme will continue (do not add
the drain hose is frozen.detergent for this programme).
Reselect the desired programme and start again If the fault recurs, carry out the above steps again
to continue with the programme (do not add
and contact After-Sales Servic?After-Sales e (see
detergent for this programme).Service?).
If the fault re-occurs, contact After-Sales Service
(see ?After-Sales Service?).
the ?Rinse Hold? button is pressed: terminate
this option.
29 |