42007bGB.FM5 Page 9 Wednesday, September 27, 2000 3:28 PM
INSTALLATION
Unpack the appliance and ensure that thIf te he plug and socket are not of the same
various elements (plastic bags, polystyrentypee , have the socket replaced by a qualified
pieces, etc.) are well out of the reachelect of rician.
children. Do not use extension leads or adaptors.
Remove the 4 protection pieces inserted DISCONNECTING THE APPLIANCE
between lid and appliance (A). Electrical disconnection must be possible
Important: place two of the four either by unplugging the appliance or by
protection pieces (A), used to protect the
lid during transport, in the capacitor means of a double-pole switch located upline
plastic holder recess on the rear of the from the socket.
appliance (E).
This operation is necessary in order to A
ensure the proper distance of the appliance
from the wall.
Remove the packaging from the bottom
(B) of the freezer.
After connecting the appliance to the
mains, when the right temperature has C
been reached (about an hour), ensure that
the fast freeze function is inactive (yellow
LED is off).
B
During the freezing phase, the lid does
not open until the right temperature has
been reached (about 1 hour).
Ensure that the defrosting water drainage
plug is correctly positioned (C).
Ensure that the lid seal is not damaged: to
remove any deformation, warm the seal with
a hair dryer.
70 mm
Before connecting the appliance to the mains
supply, ensure that the voltage corresponds
to that given on the rating plate (see figure 70 mm
below).70 mm
After the freezer has been installed, check
that it is not resting on the mains cable.
Install the appliance in a dry, well ventilated
room. Avoid locations near a source of heat
or in direct sunlight.
For optimum appliance operation and in
order to avoid damage when the lid is
opened, leave a space of at least 7 cm from
the rear wall and 7 cm at the sides.
Fit the accessories.
ELECTRICAL CONNECTION
Electrical connections must be made in
accordance with local regulations.
Data regarding voltage and absorbed power
are given on the rating plate on the rear of the
appliance(D) .
Regulations require that the appliance is
earthed. The manufacturer declines all
liability for injury to persons or animals
and for damage to property resulting from
failure to observe the above procedures
and reminders.
9 |