Technical Manual
Control 1X/1Xtreme
EXPLODED VIEW
Screw
3.5x10m/m
Black Plated
C1006XControl 1X/1Xtreme
Crossover Ntworke(NOT for SALE)
EVA Gasket
Screw
Black
4x8m/m
Black Plated
Front Baffle
Black
C1002X
Screw
Tweeter
T4x35m/m
Black Patled
Die-Cast Alum.C1004X
Safety Ring, BlackMe tal Grille
Black
Nut
M5x0.8m/m
ZincPl ated
Nut, M4x0.7Px3t
m/m Zinc Plated
C1003X
4-1/2" Woofer
Tweeter
Difusef r
WasherScrew
4x18m/m
Black PlatedSpring
Control 1X - C1005X
Control 1Xtreme - C10028X
Logo Badge
on Grille
Grilel Holding Ring
TO SERVICE THE CONTROL 1X/1XTREMEBlack
1. Remove the grille.
2. Remove all (6) 1-3/8" Allen Head screws holding the front baffle to the enclosure.
3. Separate the front baffle w/drivers from the enclosure.
DRIVER REMOVAL � both woofer and tweeter are bonded to the front baffle with adhesive.
Unclip FASTON connectors from both woofer and tweeter.
a) Woofer removal
Remove all (4) machine screws; rear nut can be held by long-nosed pliers while screws are turned.
Apply heat gun (750!) to area around woofer basket until adhesive softens enough to extract the woofer.
b) Tweeter removal
Remove both (2) Phillips screws.
Apply heat gun (750!) to area around inside of cavity until adhesive softens enough to extract the tweeter.
After removal, take care not to lose or misplace the small clear plastic diffuser should it become dislodged.
CAUTION: Too much heat applied in one area too long could warp the front baffle.
DRIVER REPLACEMENT
Both woofer and tweeter must have a bead of adhesive applied to the outer rim only upon reassembly.
Silicon Sealer or Rubber-to-metal cement is recommended.
Control 1X/1Xtreme
JBL Consumer Products, 250 Crossways Park Drive, Woodbury, New York 11797
Rev 0 2/2002 |