ADJUSTMENT INSTRUCTION
1. Application Object3.2.5 Screen Adjustment Instructions
This document is applied to 23"/26"/32" Wide LCD TV whichAdjustment Content CMD(ASCII) VALUE(hex) Detail Explanation
is manufactured in Monitor Factory or is produced on the
1Mode SelectKb10,20,30,40,60 10 : RF(TV)
basis of this data.
20: AV1
2. Designation30 : S-Video
2.1 The adjustment is according to the order which is40 : Component
designated and which must be followed, according to the
60 : PC
plan which can be changed only on agreeing.
2.2. Power Adjustment : Free Voltage2Sub BrightnessAh00 ~ 0X64
2.3. Magnetic Field Condition: Nil.
2.4. Input signal Unit : Product specification standard 3Sub ContrastAg00 ~ 0X64
2.5. Reserve after operation : Above 2 hours4R _ Offset Adjustment Aa00 ~ 7f
2.6. Adjustment equipments : Pattern Generator(MSPG925F),5G _ Offset Adjustment Ab00 ~ 7f
DDC Adjustment Jig equipment HDCP Adjustment Jig
6B _ Off\set Adjustment Ac00 ~ 7f
equipment.
7R _ Gain Adjustment Ad00 ~ ff
3. Adjustment8G _ Gain Adjustment Ae00 ~ ff
3.1 Adjustment Details 9B _ Gain Adjustment Af00 ~ ffThe data which is adjusted store
The machine can be adjusted by itself automatically with
10 Adjust Data Saveai00The signal Adjustment was
factory automatic equipment, in case error occurs, set
manual adjustment to standard. 11 Adjust OKak00completed
3.2 Adjustment signal Composition of The Auto
3.3 PC signal Gain/Offset Adjustment
Adjustment equipment
3.2.1 RS-232C Interchange(Execute first of all in adjustment process)
- just from F/W Version vcti 32.0, scaler 32.0
9600bps, Pin#2 : Rx, Pin#3 : Tx, 8bit, STOP bit=1, No3.3.1 Adjustment Preparation
Parity
Execution of RF no signal during Heat Run over 30min
3.2.2 Adjust data savePattern generator signal is connected to the DVI-I Jack of
Save the adjusted data to the EEPROM with defaultLCD TV.
3.3.2 Auto Gain/Offset Adjustment .
value
To use Pattern Generator(MSPG-925FS), Apply Model :
37, pattern : 19 (XGA(1024 X 768)60Hz, Half white and
half black pattern signal (Don't apply 16 gray signal)ai - 0 - 00
3.2.3 Adjust OKPress IN-START Key by using the Remote Controller
(SVC), after converting to Adjustment-Mode, press VOL+
Key consecutively in Auto-Gain Menu.ak - 0 - 00
After adjustment is complete, pressing enter key, stores
and completes the process.
3.2.4 Screen Adjustment Instruction Forms
CMD1 CMD2 SetID(0) Value 3.4 Video signal Gain/Offset Adjustment
a. CMD1,CMD2 : Instructions operated by Monitor
b. SetID L 0h Set always 0 in Adjustment(Auto adjustment)
Execution of RF no signal during Heat Run over 30min
VALUE : Adjustment Value
Connect to the LCD TV component input terminal with
Patten Generator(MSPG-925FS)
Convert INPUT MODE to component & PSM mode to
Standard .
Connect RS-232C Communication Cable to the Auto
Adjustment Equipment and SET's upgrade Port
- 10 - |