Power Tool Safety Rules
Read and understand all instructions. Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious personal injury.!WARNING
SAVE THESE INSTRUCTIONS
Work Areacord to carry the tools or pull the plug
Keep your work area clean and well lit.from an outlet. Keep cord away from
Cluttered benches and dark areas inviteheat, oil, sharp edges or moving parts.
accidents.Replace damaged cords immediately.
Damaged cords increase the risk of electric
Do not operate power tools in explosiveshock.
atmospheres, such as in the presence of
flammable liquids, gases, or dust. PowerWhen operating a power tool outside, use
tools create sparks which may ignite thean outdoor extension cord marked "W-A"
dust or fumes.or "W." These cords are rated for outdoor
use and reduce the risk of electric shock.
Keep by-standers, children, and visitorsRefer to ORecommended sizes of Extension
away while operating a power tool.
Cords� in the Accessory section of this
Distractions can cause you to lose control.manual.
Electrical SafetyPersonal Safety
Grounded tools must be plugged into anStay alert, watch what you are doing and
outlet properly installed and grounded in
accordance with all codes anduse common sense when operating a
power tool. Do not use tool while tired or
ordinances. Never remove the groundingunder the influence of drugs, alcohol, or
prong or modify the plug in any way. Do
medication. A moment of inattention while
not use any adaptor plugs. Check with aoperating power tools may result in serious
qualified electrician if you are in doubt as
personal injury.
to whether the outlet is properly
grounded. If the tools should electricallyDress properly. Do not wear loose
malfunction or break down, groundingclothing or jewelry. Contain long hair.
provides a low resistance path to carryKeep your hair, clothing, and gloves away
electricity away from the user. Improperfrom moving parts. Loose clothes, jewelry,
grounding can shock, burn or electrocute.or long hair can be caught in moving parts.
Grounded tools are equipped with threeKeep handles dry, clean and free from oil
conductor cord and three prong type plugs.and grease.
Before plugging in the tool be certain theAvoid accidental starting. Be sure switch
outlet voltage supplied is within the voltage
marked on the nameplate. Do not use OACis OOFF� before plugging in. Carrying tools
with your finger on the switch or plugging in
only� rated tools with a DC power supply.
tools that have the switch OON� invites
Avoid body contact with groundedaccidents.
surfaces such as pipes, radiators, ranges
and refrigerators. There is an increasedRemove adjusting keys or wrenches
risk of electric shock if your body isbefore turning the tool OON�. A wrench or
grounded. If operating the power tool ina key that is left attached to a rotating part of
damp locations is unavoidable, a Groundthe tool may result in personal injury.
Fault Circuit Interrupter must be used toDo not overreach. Keep proper footing
supply the power to your tool. ElectricianOs
and balance at all times. Proper footing
rubber gloves and footwear will furtherand balance enables better control of the
enhance your personal safety.
tool in unexpected situations.
Don't expose power tools to rain or wet
Use safety equipment. Always wear eye
conditions. Water entering a power tool will
increase the risk of electric shock.protection. Dust mask, non-skid safety
shoes, hard hat, or hearing protection must
Do not abuse the cord. Never use thebe used for appropriate conditions.
-2- |
ACEC
