BM 2610925940 6-05 6/9/05 3:21 PM Page 9
Operating Instructions
VARIABLE SPEED CONTROLLED
FIG. 2
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool speed can be
controlled from the minimum to the maximum
nameplate RPM by the pressure you apply to
the trigger. Apply more pressure to increase
the speed and release pressure to decreaseADJUSTABLE
speed. This accurate speed control enablesCLUTCH
you to drill without center punching. It also
permits you to use as a power screwdriver.
Bits are available for driving screws as well as
running bolts and nuts.
DRILL/HAMMER DRILL SELECTOR RING
FORWARD/REVERSING LEVER &The selector ring allows the tool to be set for
TRIGGER LOCKvarious drilling/hammer drilling applications.
Your tool is equipped with a forward/Rotate the selector dial right or left
reversing lever and trigger lock located aboveFig. 3
Fig. 1
Drill only action: For drilling in woods,
for changing rotation of the chuck, and formetals, plastics or other non concrete
locking the trigger in an OOFF� position to helpmaterials.
prevent accidental starts and accidental
Drill with hammer action: For drilling in
battery discharge. For forward rotation, (with
chuck pointed away from you) move the leverconcrete, asphalt, tile or other similar
hard materials.
to the far left. For reverse rotation move the
lever to the far right. To activate trigger lockThe hammer drill position overrides the clutch
move lever to the center off position.for hammer drilling.
Do not change direction ofFIG. 3
rotation until the tool!CAUTION
comes to a complete stop. Shifting duringMODE
SELECTOR
rotation of the chuck can cause damage toRING
the tool.
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the high or low position.
ATTENTION: If your tool appears to beBRAKE
running, but the chuck will not turn, check toWhen the trigger switch is released it
make sure the gear shifting switch is pushedactivates the brake to stop the chuck quickly.
fully into desired setting.This is especially useful in the repetitive
driving and removal of screws.
ADJUSTABLE CLUTCH
Your tool features 15 clutch settings. OutputBIT STORAGE ADAPTER
torque will increase as the clutch ring, isYour tool is equipped with a bit storage
rotated from 1 to 15. The drill O � positionadapter that will allow you to store a longer bit
will lock up the clutch to permit drilling andif desired. To install bit adapter, remove bit
driving heavyduty work, and also enables bitsfrom standard storage area, then snap
to be changed quickly and easily in theadapter into itOs place. To use, hold bit
Fig. 2Fig. 1
-9-
1511315113
13151 |