VACUUM TOILET OPERATION
1. To add water to the toilet before2. To flush toilet, press flush lever3. Do not dispose of sanitary napkins
using, raise flush lever until desiredsharply down to the floor until contentsor other non-dissolving items in toilet,
water level is reached. Generally, moreclear bowl. A sharp popping noise issuch as facial tissue or paper towels.
water is required only when flushingnormal when the vacuum seal is bro-These items can cause plugging of the
solids.ken and flushing action begins.system. Refer to the Deodorants and
Be sure to hold lever down for threeSpecial Tissue section in this manual
seconds. If flush lever is accidentallyfor more information.
released before waste clears bowl, do
not attempt to flush toilet again until
vacuum pump stops running. A small
amount of water should remain in the
bowl after flushing.
HOLDING TANK OPERATION - DISCHARGE
1. Position vehicle close to sewage dumping facility.
2. Unroll discharge hose, remove plastic cap, and insert end into dumping facility.
3. Activate discharge pump.
4. After tank is empty, the tank can be rinsed. (Note: Rinsing systems vary by vehicle. Consult vehicle dealer.)
5. Discharge rinse water into dumping facility. Drain all water from discharge hose. Put plastic cap on end of hose.
Roll up and store hose.
CLEANING - HOLDING TANK
A small amount of water remains in all holding tanks. It is good practice to rinse the tank after the contents have been
?
discharged. This can be accomplished by adding water to the toilet bowl. Add 237 ml (8 oz.) of SeaLand Holding
Tank Deodorant to the bowl. Flush the entire contents into the holding tank and continue flushing until the discharge
from the holding tank is clear.
Do not use chlorine-based cleaners, caustic cleaners or chemicals, such as drain-opening products, as they
may damage the system?s seals and hose.
WINTERIZING - HOLDING TANK
If using antifreeze to winterize the holding tank system, use only propylene glycol freshwater antifreeze that does not
contain alcohol. Antifreeze that contains alcohol will result in damage to your sanitation system.
1. Pump out holding tank.
2. Thoroughly flush the system with fresh water before adding propylene glycol freshwater antifreeze to the HTS.
3. Turn off electrical power.
6 |