START AND STOP
Control before startingWarm engine
IGNITION:
Y Check the cutters. Never
Set the stop switch to the
use cutters that are blunt,
start position.
cracked or damaged.
CHOKE:
Set the choke control in the
Y Check that the machine
choke position and then
is in full working order.
back again to its original
Check that all nuts and
position (B)
bolts are tightened
In this way only the start
correctly.
B
throttle is applied with no
choke.
Y Check that the cutting attachment always stops when the
AIR PURGE:
engine is idling.
Press the air purge dia-
phragm repeatedly until fuel
Y Only use the machine for what it is intended for.
begins to fill the diaphragm.
The diaphragm need not be
Y Ensure that the handle and safety functions are in order.
completely filled.
Never use a machine that lacks a part or has been modified
outside of the specifications.
Start and stop
Start
Press the machine body
WARNING!
against the ground using yourThe gearbox and clutch drum must be
!fitted before the machine is started,left hand (NOTE! Not your
otherwise the clutch can come loose andfoot). Grip the starter handle,
cause personal injury.slowly pull out the cord with
Always move the machine about 3 metresyour right hand until you feel
from the filling position before starting.
some resistance (the starter
Place the machine on a firm surface. Make
pawls grip), now quickly and
sure the cutting attachment cannot come
powerfully pull the cord.
into contact with any object. Make sure
Reset the choke control as
that no unauthorised persons are in the
soon as the engine fires andworking area, otherwise there is a risk of
serious personal injury.repeat until the engine starts.
When the engine starts
quickly apply full throttle and
the start throttle will auto-
Cold engine
matically disengage.
IGNITION:
Set the stop switch to the
NOTE! Do not pull the
start position.starter cord out completely
CHOKE:
and do not release the starter
Set the choke control in the
cord from the fully extended
choke position (A).position. This can damage the
The choke position is also
machine.
the automatic start throttle
position.
NOTE! If the outside
A
temperature is very low and
the machine has not beenStop
used in the last hour, let theThe engine is stopped by
engine warm up on startswitching the ignition off
throttle setting for oneusing the stop switch.
minute.
"
AIR PURGE:
Press the air purge dia-
phragm repeatedly until fuel
begins to fill the diaphragm.
The diaphragm need not be
completely filled.
12 � English |