ASSEMBLY
MOWER DECK BAFFLE (See Fig. 1)COVER SEAL (See Fig. 3)
1Use Hardware - - GROUP "A"3No hardware required
Raise your tractor mower deck to its highest position.Align mark on seal with mark at cover opening.
Install the hex bolts, locknuts and acorn nuts throughWork seal into opening so cover sits between flanges of
mower deck housing as shown.seal.
Tighten all hardware securely.ACORN NUT
DISCHARGE
GUARD
ACORN NUT
LOCKNUT
ALIGNMENT
LOCKNUTMARKS
HEX BOLT
HEX BOLTCOVER SEAL
FIG. 1
FIG. 3
REAR MOUNTING BRACKET
2(See Figs. 2A & 2B)SUPPORT POST (See Fig. 4)
NOTE: If your tractor already has four (4) shoulder boltsUse Hardware - - GROUP "C"
4
installed on the rear drawbar, simply hang the mounting
bracket, lanced tabs towards bottom, on the bolts. Discard
CAUTION: Container support is spring
hardware group "B" and disregard the remaining Step 2loaded and locked to the cover. Handle
instructions.cover assembly carefully so as not to
unlatch the cover from the container
support.
Rotate cover assembly onto its side as shown.
Assemble support post to container support with the
three (3) carriage bolts and locknuts. Tighten securely.
SHOULDER
BOLTS
LANCED TABS
TOWARD BOTTOM
CARRIAGE
FIG. 2ABOLTS
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
Use Hardware - - GROUP "B"
Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
SUPPORT
Hang the mounting bracket, lanced tabs towards bottom,POST
on the bolts.
SELF
TAPPING
SHOULDERLOCKNUTS
BOLTS
FIG. 4
LANCED TABS
TOWARD BOTTOM
FIG. 2B
7 |