ASSEMBLY
BOLTS
REAR MOUNTING BRACKET
(See Figs. 1A, 1B & 1C)
1
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the mounting
bracket, lanced tabs towards bottom, on the bolts. DiscardLOCKNUTS
hardware group "A" and disregard the remaining Step 1
instructions.
LANCED TABS
TOWARD BOTTOM
FIG. 1C
SHOULDER
BOLTS
COVER SEAL (See Fig. 2)
2No hardware required
Align mark on seal with mark at cover opening.
LANCED TABS
Work seal into opening so cover sits between flanges of
TOWARD BOTTOM
seal.
FIG. 1A
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.ALIGNMENT
MARKS
Use Hardware - - GROUP "A"
Only one set of hardware in GROUP "A" will be used to mount
the rear mounting bracket. To determine which set is correct
for your tractor, check to see if there are (2) two upper corner
ribs on each side of drawbar. If your tractor has the upper
corner ribs, use the (4) four self tapping shoulder bolts. If your
COVER SEAL
tractor does not have the corner ribs, use the set of (4) four
bolts and locknuts.
FIG. 2
SELF TAPPING SHOULDER BOLTS (See Fig. 1B)
SUPPORT POST (See Fig. 3)
Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.3Use Hardware - - GROUP "B"
Hang the mounting bracket, lanced tabs towards bottom,
CAUTION: Container support is spring
on the bolts.
loaded and locked to the cover. Handle
UPPER CORNERcover assembly carefully so as not to
RIBS
UPPER CORNERunlatch the cover from the container
RIBSsupport.
SELF
Rotate cover assembly onto its side as shown.
TAPPING
SHOULDERAssemble support post to container support with the
BOLTSthree (3) carriage bolts and locknuts. Tighten securely.
CARRIAGE
BOLTS
LANCED TABS
TOWARD BOTTOM
FIG. 1B
BOLTS AND LOCKNUTS (See Fig. 1C)SUPPORT
POST
Assemble the mounting bracket, lanced tabs towards
bottom, using the four smaller inside holes on the
drawbar.LOCKNUTS
Install the four bolts and locknuts as shown and tighten
securely.
7FIG. 3 |