Samson AirLineSetting Up and Using Your AirLine System
control is at its minimum setting, the AirLine system always provides maximum range without dropout; -however, depending upon the par
ticular environment your system is used in, you may need to reduce that range somewhat in order to eliminate band noise when the AF1
or AG1 transmitter is turned off. To do so, use the provided screwdriver to rotate the Squelch control completely counterclockwise (to the
Min position), then slowly turn it clockwise until the noise disappears. If no noise is pr-esent at any position, leave it at its fully counter
clockwise Min position (so as to have the greatest overall range available).
ENGLISH
12. When first setting up your AirLine System in a new environment, its always a good idea to do a walkaround in order to make sure that
coverage is provided for your entire performance area. Accordingly, turn down the level of your - audio system and turn on both the trans
mitter and receiver. Then restore the level of your audio system and while playing your electric guitar or bass at a normal performance level,
walk through the entire area that will need to be covered. As you do so, observe the TX/Peak LED on the AP1 receiver to make sure that it
is steadily lit green, indicating that it is receiving sufficiently strong RF signal. Always try to minimize the distance between transmitter and
receiver as much as possible so that the strongest possible signal is received from all planned transmission points. In certain environments,
it may be desirable to angle the AP1s antennas differently from the vertical position.
If you have followed all the steps above and are experiencing difficulties, contact your local distributor or, if purchased in the United States,
call Samson Technical Support (1-800-372-6766) between 9 AM and 5 PM EST.
14 |
ACEC
