Setting the alarmCanceling the alarm
When the radio is on/standby, repeatedly press and release theSame procedures of setting the alarm, press and release Tuning
Advanced INFO button until the lower line of he display shows alarm
status. Press Tuning Control button to select Alarm Status on/off.Control button to switch the alarm off.
During Alarm Status in ON status, display will auto switch to alarm
time setting. The minute will start to flash, rotary the tuning control
knob to select required minute then press and release the tuning
button again, the hour will start to flash, rotary the tuning control knobSystem reset
to select required hour, then press and release the tuning buttonIf your radio fails to operate correctly, or some digits on the display
again to finalize alarm time setting. Display will show Alarm Statusare missing or incomplete, carry out the following procedures.
ON after completing the alarm settings.1. Switch on your radio.
2. Continuously press Advanced INFO button until display lower
part shows ? Customer.....?, press and release Advanced INFO
Select alarm by radio or beep button until display lower part shows System Reset.
During Alarm Status ON, rotary the tuning control button to select Press and release Tuning Control knob, the radio will be reset
Alarm type (Radio or Beep) pressing and releasing the tuning control and quick scan 10A-12D for services and stop at the first
service found. The RESET will clear all the previous memory
button to change alarm type.
presets and settings.
Stop the alarm
When alarm is active, press the Standby button to stop the alarm
(radio and buzzer).
Snooze
To interrupt the alarm signal (radio or beep), press Tuning Control
button. The alarm stops and begins again with interval of 5 minutes.
The alarm will continue for an hour (radio, 30 minutes for Beep) if not
being interrupted. Display will show during Snooze status.
15
DDR-3_381K801A_GB.p650422,¤¤ 2016 |