�
Model 526T Series II Super Punch
Microphone User Guide
TRANSISTORIZED BASE STATION MICROPHONE
Replaces either ceramic or dynamic original equip-
ment microphones
Excellent response for single-sideband transmission
Uses readily available 9-volt battery?low current
drain for long life
Low hum pickup, minimum susceptibility to RF inter-
ference
Momentary or locking press-to-talk transmit/receive
switch -?Million Cycle? leaf-type
Universal six-wire cable for instant microphone-trans-
ceiver connection
�
Sturdy, high-impact ARMO-DUR case
Rugged and dependable under all operating
conditions
GENERALBATTERY INSTALLATION
�
The Shure Model 526T Series II SUPER PUNCH base
Model 526T Series II uses a 9 Vdc battery (90AJ1371).To
station microphone is designed for clearer transmission and
install the battery, proceed as follows:
improved reliability. This transistorized microphone can be
used to replace ceramic or dynamic, high- or low-impedance1. Loosen two screws (located underneath base) holding
microphones supplied as original equipment.battery retaining clip, and remove battery retaining
clip.
Model 526T Series II provides crisp, undistorted voice re-
sponse with adjustable volume control for optimum intelligi-
2. Connect terminal strap to battery.
bility of transmission.
3. Insert battery in VELCRO strap of battery retaining
The microphone is designed for maximum versatility in
cllip and fasten VELCRO strap.
base station operation. It has a momentary or locking press-
to-talk transmit/receive switch for greatest ease of use, and
4. Insert battery retaining clip in base and tighten screws
a modulation level volume control for highest undistorted
securely.
output with high- or low-impedance inputs. The supplied six-
wire cable and triple-pole double-throw switch are arranged
CONNECTIONS
for universal microphone-transceiver connection.
The microphone is not affected by heat or humidity, and itModel 527T Series II can be connected to an input (trans-
is oustanding in its ability to resist mechanical shocks andceiver, transmitter, or amplifier) of 500 ohms or more. For de-
�
vibration. Its exclusive ARMO-DUR case is immune to oil,tailed instructions for connecting the 526T Series II to CB or
grease, fumes, salt spray, sun, rust, and corrosion. The ?Mil-ham transceivers. If your unit is not listed in the Guide, con-
lion Cycle? leaf-type press-to-talk switch is designed to with-tact your dealer or Shure Incorporated for information.
stand rigorous operating conditions and constant use.
A piece of tubing is attached to the plug end of the cable
Microphone Features:for use as a strain relief for plugs with large cable entry holes.
Dynamic microphone with transistorized preamplifierRemove the tubing when not required.
Adjustable volume control for optimum transmiterThe internal connections of Model 526T Series II are as
modulation and maximum intelligibilityshown in Figure 1.
é2001, Shure Incorporated
Printed in Mexico
27B1468 (AI) |