Cable Box Connections
2
f you cable signal uses a cable box or
Cable Signal IN
Idecoder, follow the easy steps below to
from the Cable
complete the connection.Company
Cable Box (w/RF In/Outputs):
This connection will be mono.
21
Connect the Cable CompanyAUDIO INSPDIFIN OUTVIDEO
supplied cable to the signalTOCABLEINIRDVD-D OUTR LS-VIDEO
1TV/VCRAUDIO OUTY Pb Pr
IN(put) plug on the back of theUSBPASSCARDTVOPTICALSPDIF
Cable Box.
Jack Panel Back of Cable Box
Using a separate round coaxial
cable, connect one end to the
2
OUT(put)(TOTV) plug on
3
the back of the Cable Box.
Connect the other end of the
round coaxial cable to the 75&75&75&
3
input on the back of the television.
Screw it down finger tight. Round 75&Jack Panel Back of TV
Coaxial Cable
NOTE: If applicable, set the OUTPUT
CHANNEL SWITCH on the back of the
cable box to CH 3 or 4. Tune the TV to
the same channel and change channels
at the cable box. In some cases, the
cable box will automatically tune to
either channel 3 or 4, change channels
until the picture appears.
Helpful Hints
If no Video Signal is present, the TV
will shut itself off in about 10 minutes.
If the TV is tuned to the AV channel
and there is no Video Signal present,
the screen will remain black and the
TV will shut itself off in about 10 min-
utes. |
ACEC
PHILIPS
