Newsflash and subtitle pagesPag e hold
These special pages are displayed as a small box ofWhen information on one teletext page will not fit on
text on the television picture. The page numbers arethe screen, sub-pages are shown in order (see
given by the service provider (for example, on BBC1�Sub-pages aboveO). To keep a sub-page on the screen
Ceefax, page 888 gives you subtitles).for longer than usual, press the button.
To cancel page hold mode, press again.
Pag e headings (the red,green,yellow and
blue buttons)Large character display
The four coloured page headings at the bottom of theKeep pressing the button to change the character
screen are set by teletext. To see the pagesize. Press the button once to display the top half
corresponding to one of these headings, press theof the page at twice its normal height. Press the
matching coloured button. Each time you change thebutton again to display the bottom half of the page at
page it will take a little time for the new page to betwice its normal height. Press the button again to
found and displayed.return the text to its normal size.
Sub-pa gesReveal ans wer
Some teletext pages contain too much information toUse this button on certain pages to reveal the
fit on the screen at once, so they are split up intosolutions to quizzes and so on. Press the button
sub-pages and shown in order. The service provideronce to reveal a hidden answer and press it again to
usually displays a label in the top right-hand corner ofhide it.
the screen to show which sub-page is being shown.
For example �3/6O shows that you are looking at the
third of six pages.
The scart socket
The scart socket at the back of the television is a convenient way of connecting audio and video (AV) signals to
and from the television. As the signals are in a more basic form than the signal at the aerial socket, they are less
likely to be affected by interference and other things that can reduce picture quality.
To select the scart channel
Press the 0 button on the remote control. �AVO will be displayed for a few
seconds and you will see the picture from any equipment that is connected to0
the scart socket (if that equipment is switched on). If there is no signal at the
scart socket, the screen will remain dark.
The table below describes the facilities supported by the AV channel on your television.
Where theRGB
AV featuresConnector typeAVAVAV switch AV outputRGB blanking
inout(pin 8)comes from(pin 16)
AV1ScartYesYesYesTunerYesYes
Video and RGB
The sharpest and clearest possible picture is reproduced from separate red, green and blue signals (RGB). Only
certain computers and high-quality digital equipment produce this form of signal. Most equipment produces a
�composite video, blanking and synchronisationO signal (CVBS), usually just called �videoO.
Automatic AV mode or video switching
Some equipment provides an automatic switching signal, so that the video recorder (and so on) �tellsO the
television to reproduce its video and audio signals. For example, if you play a video tape, you will not have to
press the �0O button on your remote control, as the television will automatically switch to the video channel.
Equipment that can be connected to the television
You can usually connect video recorders, camcorders, satellite receivers, PAL video disc players, audio amplifiers
and video games to this television, but we cannot guarantee that all combinations of equipment will work. You
can buy many different cables to connect these things.
7 |
ACEC
PHILIPS
