ASSEMBLY
Fitting a blade guard, grass blade Fitting the blade guard and saw
and grass cutter (235R, 235FR)blade (232R)
Y Secure the adapter (H) using the four screws (I).G
FI
E
H
D
B
AC
Y The blade guard (A) is Ţtted using 4 screws (L) as shown.
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.A
L
Y Hook the blade guard/combination guard (A) onto the
Å¢tting on the shaft and secure with the bolt.
CAUTION! Ensure that the guard extension is removed.
Use the recommended blade guard. See the Technical
A
data section.
Y Fit the drive disc (B) on the output shaft.
Y Fit the drive disc (B) on the output shaft.
Y Turn the blade shaft until one of the holes in the drive disc G
F
aligns with the corresponding hole in the gear housing.
D
Y Insert the locking pin (C) in the hole to lock the shaft.
Y Place the blade (D), support cup (E) and support �ange
(F) on the output shaft.
B
Y Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
C
guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (Caution! Y Turn the blade shaft until one of the holes in the drive disc
left-hand thread). aligns with the corresponding hole in the gear housing.
Y Insert the locking pin (C) in the hole to lock the shaft.
Y Place the blade (D) and support �ange (F) on the output
shaft.
Y Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (Caution!
left-hand thread).
Y When loosening and tightening the saw blade nut, there is
a risk of injury from the teeth of the saw blade. You should
therefore always ensure that your hand is shielded by the
blade guard when doing this. Always use a socket
spanner with a shaft that is long enough to allow this. The
14 � English |
ACEC
HUSQVARNA
