AR-200_e.book 50 Z8 ???? ??e?? xýe
U xý9=?p?? Â
Troubleshooting
About recordingAbout playback and recording of
Recording does not startMIDI phrases
Y In trigger recording, recording starts automatically when MIDI phrases cannot be recorded correctly
the audio input is of a higher level than the trigger level Y Some MIDI sequencers output MIDI sound generator
(lever for starting recording). Adjust the input level so setup messages (tone settings for each part, volume
that recording is allowed to start.information, effects data, etc.) when a song is selected,
? " Trigger recording standby." (p. 23)and this may prevent MIDI messages from being
recorded correctly when recording with the AR-200
About playbackbegins. In such instances, start recording with the AR-
200 first, then after this select and play back the song
Control Input Playback (Direct/Binary) does from the MIDI sequencer.
not work as intended
MIDI data cannot be recorded
Y Make sure the MODE switchesO settings (Direct/Binary) Y When recording MIDI data, switch to MIDI Recording
are selected correctly. You cannot achieve control input
playback merely by connecting a device to the port. Be mode.
sure to set the control input mode and match the method ?"Recording and Playing MIDI Data (MIDI Phrase)"
used for connecting to the connectors.(p. 26)
? "MODE SW Settings" (p. 56)MIDI phrases are not played back
Phrases in Direct Playback cannot be selected Y Is the MIDI Receive channel set to OOff?�
as intended? "MIDI Receive channel Settings (MIDI channel)"
Y When the card is formatted, phrase assignments for Port (p. 44)
Nos. 1 through 9 are such that Phrase 0001 is assigned to
Port No. 1, Phrase 0002 to Port No. 1, and so on up to
About MIDI Control Playback
Phrase 0001, which is assigned to Port No. 9. Check to
make sure that the phrases are properly selected.Phrases cannot be played back as intended in
MIDI Control Playback
Phrases play repeatedly in Direct Playback
Y Check to make sure that OINTERVAL PLAYBACK� is Y When a card is formatted, Program Change 1 is set to C-
not selected with the MODE switch settings.1: 0001-G9:0128. Program Changes 21-30 have Phrases
0001-1000 assigned to them. Phrases 001-500 are
? "MODE SW Settings" (p. 56)assigned to Program Changes 21-30 for compatibility
The AR-LINK function does not work as with the AR-2000. Confirm that the phrase you want to
intendedplay back is correctly specified.
Y In the AR-LINK settings, is OAR-LINK Mode� set to * By transmitting program change 128, you can then send a
OOff?�Note On message for a note number to interrupt a currently
When using AR-LINK, set this to OSlave� to match your playing phrase.
usage conditions. In addition, check the device connections
(OUT, IN) for the AR-LINK connector.
50 |
ACEC
ROLAND
