1gb33020a.fm5 Page 10 Tuesday, February 20, 2001 4:37 PM
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself
with the help o?fTro thue bleshooting gu?.ide
2. Switch the appliance on again to see if the
problem has been solved.
If it has not, disconnect the appliance from
the power supply and wait for about an hour
before switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
the nature of the problem
the model
the Service number (the number afteNote:r the
word SERVICE on the data plate on the The direction of door opening can be
inside of the appliance)changed. If this operation is performed by
your full addressAfter-sales Service it is not covered by the
your telephone number and area codewarranty.
INSTALLATION
Install the appliance away from heat so Regulaturces.ions require that the appliance is
Install the appliance in a dry, well-ventilated earthed.
place.The manufacturer declines all liability for
Do not obstruct the top and bottom vent zones.injury to persons or animals and for
damage to property resulting from failure
Clean the inside (see?How to clean the to observe the above procedures and
refrigerator compartme?). ntreminders.
Fit the accessories supplied. If the plug and socket are not of the same
type, have the socket replaced by a qualified
Electrical connectionelectrician.
Electrical connections must be made in Do not use extension leads or adaptors.
accordance with local regulations.Disconnecting the appliance
Voltage and power consumption are
indicated on the rating plate (at the side of the It must be possible to disconnect the appliance
crispers).by unplugging it or by means of a two-pole switch
fitted upline of the socket.
Freestanding appliances
(not built-in)
Fit the spacers (if supplied) on the rear of the
condenser positioned at the back of the
appliance (see figure).
To optimize appliance efficiency, leave a 5
cm gap above the appliance and make sure
that adjacent kitchen units are sufficiently
distanced to allow air circulation.
Ensure that the appliance is level, using the
front adjustment feet if necessary.
10 |