1gb37030a.fm5 Page 18 Friday, February 9, 2001 7:50 PM
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself
with the help of the Trouble-shooting guide.
2. Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
?the nature of the problem
?the model
?the Service number (the number after the
word SERVICE on the data plate on theNot e:
inside of the appliance)
The direction of door opening can be
?your full addresschanged. If this operation is performed by
?your telephone number and area codeAfter-sales Service it is not covered by the
warranty.
INSTALLATION
? Install the appliance away from heat sou? If rces. the plug and socket are not of the same
Installation in a hot environment, direct type, have the socket replaced by a qualified
exposure to the sun or installation neaelr heatectrici an.
sources (heaters, radiators, cookers) will ? Do not use extension leads or adaptors.
increase power consumption and should
therefore be avoided.Disconnecting the appliance
? If this is not possible, the following minimum It must be possible to disconnect the appliance
distances must be respected:by unplugging it or by means of a two-pole switch
?30 cm from coal or paraffin stoves;fitted upline of the socket.
?3 cm from electric and/or gas stoves.
? Fit the spacers on the rear of the condenser
positioned at the back of the appliance (see
figure).
? To optimize appliance efficiency, leave a 5
cm gap above the appliance and make sure
that adjacent kitchen units are sufficiently
distanced to allow air circulation.
? Install the appliance in a dry, well-ventilated
place, and ensure it is level, using the front
adjustment feet if necessary.
? Clean the interior.
? Fit the accessories.
Electrical connection
? Electrical connections must be made in
accordance with local regulations.
? Voltage and power consumption are
indicated on the rating plate inside the
appliance.
? Regulations require that the appliance is
earthed.
The manufacturer declines all liability for
injury to persons or animals and for
damage to property resulting from failure
to observe the above procedures and
reminders.
18 |