33110Gb.fm5 Page 18 Monday, June 28, 1999 3:50 PM
Before contacting After Sales Service:
1. See if you can solve the problem yourself
with the help of the ?Trouble-shooting guide?.
2. Switch the appliance on again to see if the
problem has been solved.
If it has not, disconnect the appliance from
the power supply and wait for about an hour
before switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
the nature of the problem
the Service number (the number after the
word SERVICE on the rating plate on the The direction of door opening can be
changed. If this operation is performed by
inside of the appliance).After-sales Service it is not covered by the
your full addresswarranty.
your telephone number and area code
Install the appliance away from heat sources. Regulations require that the appliance is
Installation in a hot environment, direct earthed. The Manufacturer declines all
exposure to the sun or installation near liabilities for injury to persons or animals heat
sources (heaters, radiators, cookers) or damage to property resultwill ing from
increase power consumption and should failure to observe these regulations.
therefore be avoided. If the plug and socket are not of the same
Do not obstruct the circulation of air above type, have the socket replaced by a qualified
and below the appliance.electrician.
Clean the inside (see section ?Maintenance Do not use extension leads or adaptors.
Disconnecting the appliance
Electrical connectionIt must be possible to disconnect the appliance
Electrical connections must be made in by unplugging it or by means of a two-pole switch
accordance with local regulations.fitted upline of the socket.
Voltage and power consumption are
indicated on the rating plate located inside
the appliance at the side of the crisper.
For free-standing appliances
The following minimum distances must be
30 cm from coal or paraffin stoves;
3 cm from electric and/or gas stoves.
To optimise appliance efficiency, leave a 5
cm gap above the appliance and make sure
that adjacent kitchen units are sufficiently
distanced to allow air circulation.
Fit the spacers (if supplied) at the rear of the
appliance (see figure).
Install the refrigerator in a dry, well-ventilated
place. Make sure it is level. Adjust the front
feet if necessary.
Fit the accessories.