3gb20155new.fm5 Page 2 Thursday, February 7, 2002 6:37 PM
2.When the spin cycle is finished the programme
CONSUMPTION DATADOOR LOCK
selector moves to ?Stop?.
The door locks automatically after the programme 3. Select a drying time based on the type of fabric
Temperature LoadWaterEnergyApprox.start until the end of the programme. If the (cotton/synthetic), amount of laundry and
ProgrammeSelectorProgramme Durationprogramme selector is moved to the ?Stop? desired final results (iron/cupboard dry), using
(°C)(kg)(l)(kWh)(hours:minutes)position or if the electricity supply is interrupted, the ?Drying Time? knob.
A - Cotton90°5.0571.852:28then after approximately two minutes the door is 4. Press the?Dryer Half Load? button.
released. In this case do not open the door: 5. Turn on the water tap, check the drain hose,
B - Cotton90°5.0501.072:08use the ?ON/OFF? button to turn on
because hot water could come out of the door.
C - Cotton60°5.0530.972:00(the indicator light goes on).
CHANGING THE SELECTED PROGRAMME
D - Cotton40°5.0530.601:55
SETTING THE WASHING/DRYING CYCLE IN
To change a programme when a cycle has already
E - Synthetics60°2.5600.831:15SEQUENCE
begun:
F - Synthetics60°2.5600.421:00
1. The sequential washing and drying function
1. Switch off the appliance by pressing the
G - Wool40°1.0610.320:48can only be used for energy-saving and
?ON/OFF?button.
synthetic programmes (not wool) and starts
The use of the prewash cycle increases programme duration by approximately 15 min. Consumption data was calculated 2. Select the new programme.
based on normalized conditions in compliance with Standard IEC 60 456. The data on the ?Energy Label? refers to when the knob reaches the programme stop
3. Start the programme by pressing the
programme ?Coloured Cotton 60° C?. Consumption data in the home may vary with respect to the values in the table in mark.
relation to the water supply pressure and temperature, the load and the type of wash.The drying times shown may vary ?ON/OFF?button.2. Load the washer-dryer (according to the max.
based on the spin speed and type of fabric.drying load table) and close the door
INTERRUPTING THE CURRENT PROGRAMME
ADD THE DETERGENT, CLOSE THE DOOR?Intensive Rinse? button 3. Select a drying time based on the type of fabric
(cotton/synthetic), amount of laundry and
AND SELECT THE PROGRAMME(depending on model)To interrupt the selected programme and continue
desired final results (iron/cupboard dry), using
? The quantity of water duration of the rinse cycle it at a later time:
Add the detergent as described in the programme the ?Drying Time? knob.
are increased.
table or in the chapter ?Detergent and Additives? in ? This option is especially recommended in areas 1. Press the ?ON/OFF?button.4. Press the?Dryer Half Load? button.
the booklet.with extremely soft water, for baby linen and 2. After the desired interval has passed, press the
5. Set the ?Washing Programme? knob to the
1. Make sure that the Programme selector is set to linen belonging to skin allergy sufferers.?ON/OFF?button again.
desired programme
?Stop?.?Rinse Hold? button 6. Press the ?ON/OFF? button to start the
2. Open the water tap.AT THE END OF THE WASH PROGRAMME
(depending on model) drying cycle.
3. Set the Programme Selector to the desired only for synthetic and wool programmes
1. At the end of the programme the programme
programme.? The laundry remains in the final rinse water NOTES AND INDICATIONS FOR USE
selector moves to the ?Stop? position.
4. Set the thermostat knob to the desired without progressing to the final spin cycle to
temperature.avoid creasing and prevent colours from running.2. To unload the machine wait for the door to ? CLEANING THE FILTER
5. Set the spin selector knob to the desired speed.? This option is particularly recommended for the release (approx. 2 minutes).To ensure smooth operation of the pump,
6. Special options can be selected, if required.programmes ?Synthetics? or ?Delicate?.3. Switch off the appliance, open the door and check the filter regularly and clean it when
? This function is particularly useful if you want to
7. Check that the door is well closed and turn on the unload the washing.necessary.
postpone spinning to a later time or when you do
washer-dryer by pressing the ?ON/OFF? button. 4. Close the water tap and leave the door ajar to
not wish to spin the clothes.
The indicator light comes on, indicating that the allow the drum to dry out
To terminate the ?Rinse Hold? option
washer-dryer is on.
(depending on the model)
SETTING THE DRYING CYCLE
SELECT THE DESIRED OPTIONSsynthetic and wool programmes only
? Press the Rinse Hold button again; the load will
?Dryer half load? button 1. Load the machine according to the maximum
be spun according to the selected programme.
(depending on model) drying load table.
If you do not wish to spin the clothes, turn the
The drying function can only be used for cotton
programme selector knob to the Drain cycle, after and synthetic programmes (not wool) and
pressing the ?No Spin? button.
starts when the knob reaches the programme
?Spin Speed Reduction? Button stop mark.
Reduces or increases the spin speed from 1200 to 550.It is important that the laundry has been spun
.
and was washed with water.
Whirlpool is a registered trademark of Whirlpool USA.
5019 301 20155 |
ACEC
WHIRLPOOL
