Servicing
A: Removal Of Hob TopD: Removal Of Burner
1. Remove the panstands and each burner cap and1. Follow the procedures in Section A.
crown.2. With the aid of a 12mm spanner loosen off the pipe
2. Lift the hob from off the working top.connection nut.
3. Remove the two self tapping screws from each
burner and the two fixing screws on the right hand3. From the underside of the hob remove 2 self tapping
screws from the burner body.
side of the hob.4. Reassemble in reverse order and carry out leak test.
B: Removal Of the Hob Taps
(Isolate Electric Supply)E: Removal Of Ignitor Unit
(Isolate Electric Supply)
1. Follow the procedures in Section A.1. Follow the procedures in Section A.
2. With the aid of a 7mm spanner remove the clamping
bolt from the fixing clamp.2. Disconnect H.T. leads and the ignition switches
connector.
3. Loosen the pipe connection nut from the gas tap with3. With the aid of a pair of thin nose pliers, pull the
the aid of a 16mm spanner. Remove fixing clamps.spring clip sidewards off of the underside of the
4. Reassemble in reverse order and carry out leak test.
ignitor.
4. Reassemble in reverse order and check with wiring
C: Removal Of Mains Terminal Blockdiagram for correct reconnection.
(Isolate Electric Supply)
1. Follow the procedures in Section A.F: Remove Taps Ignition Switches
2. Disconnect supply flex connections from terminal (Isolate Electric Supply)
block.1. Follow the procedures in Section A.
3. From the underside of the hob remove 1 self tapping
screw from the terminal block.2. Disconnect the switches connector from the ignitor
unit and remove the supply cables pulling the tabs
4. Reassemble in reverse order.connection off.
3. Reassemble in reverse order and check with wiring
diagram for correct reconnection.
Repais may only be carried out by
CORGI registered engineers.
Conversion from Natural Gas to LPG
It is important to note that this model is designed forTO ADJUST THE GAS RATE
use with natural gas but can be converted for use with
butane or propane gas providing the correct injectors
With the aid of a thin bladed screwdriver completely
are fitted. The gas rate is adjusted to suit.tighten down the by pass adjustment screw, which is
located down the centre of the gas tap control shaft.
MethodUpon completion stick the replacement rating plate
on the under side of the hob.
Y Ensure that the gas taps are in the 'OFF' position
Y Isolate the appliance from the electricity supplyIMPORTANT
Y Remove all pan supports, burner caps, rings, crowns
and control knobs.The replacement/conversion of the gas hob should
Y With the aid of a 7mm box spanner the burneronly be undertaken by a competent person
injectors can then be unscrewed and replaced by the
appropriate LPG injectors.
21 |
ACEC
REX-ELECTROLUX
