Installation
nCare must be taken to ensure that the appliancen If the appliance has been transported horizontally,
does not stand on the electrical supply cable.it is possible that the oil contained in the
Important:if the supply cord is damaged, it mustcompressor flows in the refrigerant circuit. It is
be replaced by a special cord or assembly advisable to wait at least two hours before
available from the manufacturer or its serviceconnecting the appliance to allow the oil to flow
agent.back in the compressor.
nDuring normal operation, the condenser and
compressor at the back of the appliance heat up
Environment Protection
considerably. For safety reasons, minimum
nThis appliance does not contain gasses which
ventilation must be as shown in the relevant
could damage the ozone layer, in either its
paragraph.
refrigerant circuit or insulation materials. The
Attention: keep ventilation openings clear
appliance shall not be discarded together with
of obstruction.
the urban refuse and rubbish. Avoid damaging
nIf the appliance is transported horizontally, it is
the cooling unit, especially at the rear near the
possible that the oil contained in the
heat exchanger. Information on your local
compressor flows in the refrigerant circuit. It is
disposal sites may be obtained from your
advisable to wait at least two hours before
municipal authorities.
connecting the appliance to allow the oil to
nThe materials used on this appliance marked
flow back in the compressor.
with the symbol are recyclable.
nThere are working parts in this product which heat
up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
nParts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
DESCRIPTION OF THE APPLIANCE
AButter shelf with retaining rail
AA
�Shelf
�Bottle shelf
ASalad drawerA
�Storage shelves
AThermostat�
AFreezing compartment�
A
�
18 |
ACEC
SEPPELFRICKE
