Controls and FeaturesControls and Features
Front Side / Top Surface / Right SideLeft-hand Side / Rear Side
TEOPERAPCTEMPVIDEOMELAMPNUEHIDOLUMEVONETERENKEYSTETPRESCAPEEStp
1UPDOWN
9
ESCAPPRESETEMENTERMENUEVIDEOHIDEPCKEYSTONEVOLULAMPTEMPOPERASTTEAND BY
8
q
7
r
65 4 3 2w
e
1Exhaust vents6Adjustable feet (for adjusting the height and
Vents for cooling fans through which warm air comangle)es out.
pLens shift knob cap
By extending the feet, the projector angle can be
CAUTIONadjusted up to °. +7When you have mounted a lens that uses the lens shift
Do not block the exhaust vents, or heat will build upFor details, refer inside, ?Adjusting to the Inclination of the function, open this cap and rotate the lens shift knob to
possibly causing a fire. Also, do not touch the vents, Projectoror this ? on page 16.move the lens position. For more information, refer to
?Setting the Amount of Lens ? on pagShiftineg19.
could give you a low-temperature burn.7Lens
qSpeaker
2Carrying handleOne of the optional lens units should be installed before
This is the location of the built-in speaker.
Raise this handle when carrying the projector.using the projector.
A lens-hole blind cover (black one) is installed when the wConnector panel
CAUTIONSprojector is shipped from the factory.
For details, re?Connfer to ector Pan?el on page 11.
For details on the types of optional lenses available, refer
When carrying the projector, do not transmit shocks to pto it. age 18.eRear adjustable foot (for leveling the projector)
Also be careful to keep it balanced.It is set at the shortest position when shipped from the
Do not carry it while the light-source lamp is on or the CAUTIONfactory. Turn the foot to make the projector level.
cooling fan is operating. This could cause persoPlenalase consul injury.t your authorized dealer or service center for Adjustment can be made in the range° an of d -1.5+1°.5 ENGLISH
from the horizontal position. For details, refer to
3AC IN (power input) terminalinformation about attaching an optional lens.?Adjusting the Inclination of the Projector? on page 16.
This is the power input terminal where the supplied 8Lens cap
power cord is connected. For details, refer to page 30.This is the lens cap provided for the optional lens.rAir inlet
This is the air inlet. Do not cover or obstruct this slot.
4Fuse holderWhen you are not using the projector, attach the lens cap
A fuse rated 15A/250V is installed. (Power sourctoe protect the lens from dirt or being damaged. (Refer to tControl panel
protection)page 30.)For details, refer ?Control Panel on the Projectorto ? on DEUTSH
To replace the fuse, refer to page 55.9Remote sensor page 9.
When operating with the remote control, aim it toward
CAUTION
this sensor. (Refer to page 20.)AIS
When replacing the fuse, use the same rating and type. �
Otherwise, a fire may occur and/or the projector may be
damaged.
FRAN
5MAIN POWER switch
This is the main power switch. When it is turned on, the
projector goes into stand-by state, and the STAND BY
indicator on the control panel comes on. (Refer to
page 31.)
ON [ ]:The main power turns on.
OFF [ ]:The main power turns off.ITALIANO
OL
N
ESPA
67 |
ACEC
JVC
