Adjustment tips for the operating menu
Switching between channel banks
BANKVia the BANK menu, you can switch between the nine channel banks of the
transmitters and receivers. The channel banks 1 to 8 have four
switchable channels that are factory-preset to a transmission/receiving fre-
quency (see: The channel bank system on page 52). The channel bank U
(user bank) has four switchable channels to store your selection out of 1440
transmission/receiving frequencies that are freely selectable within the pre-
set frequency range.
When switching from one channel bank to another, the channel with the
lowest channel number is automatically displayed. If, during the last scan of
this channel bank, an interfering frequency was detected on the channel with
the lowest channel number (see: Scanning the channel banks for free chan-
nels (receivers only) on page 79), the receiver display panel automatically
displays the next free channel.
Switching between the channels in a channel bank
CHANVia the CHAN menu, you can switch between the four channels in a channel
bank.
Always set the transmitter and the receiver of a transmission link to the same
channel. After scanning a channel bank (see: Scanning the channel banks for
free channels (receivers only) on page 79), only the free channels are dis-
played. Set the transmitter to one of the free channels.
Selecting the frequencies to be stored
in the channel bank U
TUNEVia the TUNE menu, you can select the frequencies to be stored in the chan-
nel bank U (user bank).
When you have selected one of the channel banks 1 to 8 and then select
the TUNE menu, the transmitter or receiver automatically switches to
channel 01 of the channel bank U. In this case, U.01 briefly appears on
the display.
Use the / buttons to select the desired transmission or receiving fre-
quency. Transmission and receiving frequencies are tunable in 25-kHz
steps within a switching bandwidth of 36 MHz max. For intermodulation-
free frequencies, please refer to the enclosed frequency table.
Scanning the channel banks for free channels (receivers only)
SCANBefore putting one or several transmission links into operation, you should
scan the selected channel bank for free channels In order to ensure intermo-
dulation-free operation of your system.
79 |
ACEC
SENNHEISER
