SERVICE PROGRAM MODE13th January 1995
Mode No.FunctionSettings
5-801Memory AllResets all the correction data for process
Clear ?control and all software counters, and
returns all modes and adjustments to the
default settings.
See Service Tables - section 2.2.4 for
how to perform this SP mode.
Normally, this SP mode should not be
performed.
This SP mode is required only when
replacing the RAM board, or when the
copier malfunctions due to a damaged
RAM board.
5-802-001Free Run Mode Performs the free run
toSP5-802-001: Continuous free run
5-802-002SP5-802-002: One time free run
Before starting, close the platen or ARDF.
Press the "Start" key to start the free run.
Press the "Clear/Stop" key to stop the
free run.
5-803Input CheckDisplays the data received from sFensoror detailss, see
Mode ?and switches.Service Tables
section 2-5.
5-804Output CheckTurns on the electrical componentsFor details, see
Mode individually for test purposes.Service Tables -
section 2-6.
°5-810SC Reset ?Resets any service call condition that was
caused by a level A error (see the
Troubleshooting section).
After doing SP5-810, turn the copier main
switch off and on.
5-811Machine Serial No. Input ?
For use with features that are available in Japan only
°5-812TelephoneUse this to input the telephone number of
Number Input ?the service representative (this is
(A156 copierdisplayed when a service call condition
only)occurs.) Maximum 16 digits. Pres?" s the "
key to input a pause (-).
Press the "Clear/mode" key to delete the
input telephone number.
°5-816RDS/CSS Function Setting ?
For use in Japan only. Do not change the factory setting.
5-817Repair Time Transmission ?
For use in Japan only. Do not change the factory setting.
4-32 |
ACEC
RICOH
