CONSUMPTION DATANote: The programme stops to ?Rinse Hold? at PROGRAMME END
the time the ?Rinse Hold? light in the programme All the lights of the programme sequence
Temperature LoadWaterEnergyApprox.flow indication is on.
SelectorProgrammeindication are off.
ProgrammeTerminate the ?Rinse Hold? option:
Duration1. Turn the programme selector to the ? ?
(°C)(kg)(l)(kWh)(hours : minutes)* Press the ?Rinse Hold? button again; the position.
programme will terminate automatically with
Cotton955.053**1.902:002. Turn the water supply tap off.
the final spin cycle for the present wash
Cotton605.0480.952:20programme.3. Open the door and unload the machine.
Cotton404.5480.602:05 If you do not wish to spin the clothes, turn the 4. Close the tap and leave the door ajar to allow
Synthetics602.5550.801:30programme selector knob to the ?Drain? the drum to dry out.
Synthetics402.5550.601:20programme and press the ?Start/Pause? CHANGE THE PROGRAMME, OPTIONS
Daily403.0450.501:00button again when flashing.AFTER PROGRAMME START
Short303.0370.400:30?Spin Speed Reduction? button1. Press the ?Start/Pause? button to pause the
Delicates401.5600.600:45 Every programme has an automatic predefined programme. The light flashes.
maximum spin speed.
Wool301.0600.300:402. Select the new programme (with
Press the button to set another spin speed.temperature), any options and another spin
Silk301.0450.300:40
If the spin speed ?0? is selected, the final speed if you want.
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the spinning is cancelled but intermediate spin 3. Press the ?Start/Pause? button again. The
values in the table in relation to the water supply pressure and temperature, the load and the type of wash.peaks remain during rinse. The water is new programme continues at the same
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the
household conditions applicable at that time.drained out only.position where the previous programme was
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump interrupted. Do not add detergent for this
drains the water out.PROGRAMME START
programme.
?Prewash? buttonOpen the tap and press the ?Start/Pause?
Only for heavily soiled loads (for example sand, ADD DETERGENTS, CLOSE THE DOOR AND button. The pilot lamp of the ?Start/Pause? CANCEL A PROGRAMME BEFORE THE
SELECT THE PROGRAMMEEND
granular dirt) sensible. The cycle time increases button lights up.
Add the detergent as described in the programme approximately 15 min.1. Press the ?Start/Pause? button to pause the
The indicator lamps show the sequence reached
table or in the chapter ?Detergents and Additives? in ?Intensive Rinse? buttonin the programme. After starting the programme, programme. The light flashes.
the booklet.
More water and a longer time in rinse cycle is the sequence indication runs from left to right 2. Set the programme selector to ?Drain?. The
1. Turn the programme selector knob to the added.through Wash, Rinse, Spin.spin indicators show ?0?.
desired programme and temperature.
This option is particularly suitable for areas with 3. Press the ?Start/Pause? button to start the
2. After taking some seconds for calculation, the pilot very soft water, washing baby linen and helps When the sequence of the programme is finished
lamp of the ?Start/Pause? button is flashing.the corresponding lamp goes out.drain programme.
people with allergies.
3. The programme sequence and the DOOR LOCK
predefined spin speed indication ?Rinse Hold? button
The laundry remains in the last rinse water The door can be opened when the ?Door Open?
corresponding to the selected programme lights
up.without progressing to the final spin cycle to indication is on.
avoid creasing and prevent colours from
SELECT ANY DESIRED OPTION
changing.
Selecting any option the indication lights up. This option is particularly recommended for the
When the combination of programme, programme ?Synthetics?, ?Daily? and
?Delicates?.
additional options and temperature is not
possible, the indication lights switch off This function is particularly useful if you want to
automatically. Unsuitable combinations of postpone spinning to a later time, or if you want
options are deselected automatically.to drain only.
Whirlpool is a registered trademark of Whirlpool USA
5019 301 10229 |
ACEC
