1.6 TAKE OUT CASSETTE TAPE4. While holding down the cassette housing by hand, con-
In the event that the set enters the emergency mode as it isnect the jumper wires to a battery to run the mechanism
loaded with a cassette tape and the cassette tape cannotto the EJECT position four unloading. If this unloading
be ejected with the EJECT button, manually, take it out ofoperation is performed as the cassette housing is not
held down by hand, the front lid of the cassette may
the set according to the following procedure.damage the tape when it is ejected.
Note:If the mechanism comes into the unloading mode as5. For taking in the slack of the tape, run the mechanism
the cassette tape is not held by hand, it results in tapeto the EJECT position as the front lid of the cassette is
damage.left open, and turn the take-up gear in the forward di-
rection to wind up the tape. After confirming that the tape
1. Disconnect the set from the power source.has completely been wound up and the supply reel is
2. Remove the cassette cover assembly, Cover (VF), topidling, take the cassette tape out of the cassette hous-
cover, (See Fig. C1, C2 and C3, Page 1-1, 2, 3 and 4)ing.
3. Connect a jumper wire to each pole of the loading motor
as shown by the magnified view b (Fig. 1-6-1)
Battery
Top view
Magnified viewb
Take-up gear
Fig. 1-6-1
1-11 |
ACEC
