CT-203/KXF-4010(K) COVER( 98.4.25 0:05 PM y[W 3
CT-203/2050/KXF-W4010/W6010
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES / CAUTIONS.............2SCHEMATIC DIAGRAM ............................................9
CONTROLS ...............................................................3EXPLODED VIEW ...................................................16
ADJUSTMENT ...........................................................5PARTS LIST.............................................................18
PC BOARD ................................................................7SPECIFICATIONS...................................................23
Accessories
Audio cord................................2System control cord.....................1Except for U.S.A., Mexico, Canada,
(E30-0505-05)(E30-2816-05)U.K., Europe and Australia
AC plug adaptor.......1
(E03-0115-05)
Note : CT-203 and CT-2050 is for USA and Canada market.
Operation to reset
The microcomputer may fail into malfunction (impossibility to oper-Turn the power switch on and off again while pressing the stop
ate. erroneous display, etc.) When the power cord is unplugged(7)key on desk B.
while this unit is ON or due to an external factor. In this case, exe-
cute the following method to reset the microcomputer and return it? Please note that resetting microcomputer clears contentsstroed
to normal condition.in and returns it to the condition when it left the factory.
Cautions
Beware of condensation
When water vapor comes into contact with the surface of coldBe especially careful in the following conditions:
material, water drops are produced. If condensation occurs, cor-lWhen the unit is brought from a cold place to a warm place,
rect operation may not be possible, or the unit may not functionand there is a large temperature difference.
correctly. This is not a malfunction, however, and the unit shouldlWhen a heater starts operating.
be dried. (To do this, turn the POWER switch ON and leave thelWhen the unit is brought from an air-conditioned place to a
unit for several hours.)place of high temperature with high humidity.
lWhen there is a large difference between the internal tempera-
ture of the unit and the ambient temperature, or in conditions
where condensation occurs easily.
2 |
ACEC
