DMC-J3(K)1P( 98.4.25 19:57 y[W 3
DMC-J3
CONTENTS / ACCESSORIES
Contents
SPECIFICATIONS.........................................Top coverPC BOARD ................................................................11
CONTENTS / ACCESSORIES ....................................2SCHEMATIC DIAGRAM ............................................12
CONTROLS .................................................................3EXPLODED VIEW .....................................................15
CIRCUIT DESCRIPTION.............................................4PARTS LIST...............................................................17
Accessories
AC adapter (1) *AC plug adapter (1)Batteries : NB130 (1)Carrying case (1)
(W09-)(E03-0115-05)(W09-1237-05)(W01-0938-05)
Remocon (1)Stereo headphone (1) *
(A70-1186-05)(W01-)
* Refer to parts list on page 17.
CautionTroubleshooting
SymptomCauseRemedy
Beware of condensationUnit fails to � The disc holder is not securely closed.
� Close disc holder securely.
turn ON.
� The battery is depleted.� Charge the battery.
When water vapor comes into contact with the surface of cold materi-
� HOLD status is engaged.� Deactivate HOLD status.
al, water drops are produced.
There is no� The volume is at minimum level.�Increase the volume.
If condensation occurs, correct operation may not be possible, or thesound.
� The remote control or headphones are�Insert plug securely.
unit may not function correctly.
disconnected.
This is not a malfunction, however, and the unit should be dried.
The unit does � HOLD status is engaged.� Deactivate HOLD status.
(To do this, turn the POWER switch ON and leave the unit as it is for
not respond to � The battery is depleted.� Charge the battery.
several hours.)key operation.
� The remote control or headphone plug is� Insert plug securely.
not securely inserted.
Be especially careful in the following conditions:
� The disc holder is not securely closed.� Close disc holder securely.
Y When the unit is brought from a cold place to warm place, and there is
Sound skips. �The MD disc has, a scratch or apoor recording� Replace the MD.
a large temperature difference.
� The unit is in a place where there is� Move the unit to a place
Y When a heater starts operating.
excessive vibration.where there is little vibration.
Y When the unit is brought from an air-conditioned place to a place ofor set to "PS off" .
high temperature with high humidity.
Battery does � You are using commercial rechargeablebattery.� Use the special rechargeable
Y When there is a large difference between the internal temperature of
not charge.battery (NB-130)
the unit and the ambient temperature, or in conditions where conden-
� The unit has become hot because of� Wait until the unit has cooled
sation occurs easily.
exposure to direct sunlight etc.to normal temperature.
� You are using another AC adaptor than� Use the accessory ACadaptor.
the accessory adaptor.
Resetting the unit� The AC adaptors has become disconnected.� Connect the AC adaptorsecurely.
The unit may not operate normally due to faulty handling or adverse power current
effects caused by impact, excessive static electricity load, or power drop during use.Meaning of display messages
If this occurs, take the following measures.MessageMeaningAction
"noDISC"�There is no MD in the unit.� Insert a MD into the unit.
1Pull the AC adaptor out of the
� Nothing is recorded on this MD.� Replace the disc with aprerecorded
power outlet.To household outlet"BLANK "
MD whenplaying it back.
2Remove the rechargeable� Replace the MD.
"ERROR "� The * UTOC contents are faulty.
battery.� The disc is scratched or damaged, so�Replace the MD.
3Wait about 30 seconds.Playback is not possible.
4Plug the AC adaptor into the"LoBATT "�The inside of the unit has become hot�Wait until the inside of the unit
power outletand operate theduring charging.cools down.
unit.* UTOC : UTOC (User's Table of Contents) refers to special data put on a recordable MD,
other than TOC data.. UTOC contains writable data such as number of songs,
performance time, and other written data.
2 |
ACEC
