DMC-K3
CONTENTS / ACCESSORIES
Contents
SPECIFICATIONS .........................................Top coverPC BOARD ..................................................................9
CONTENTS / ACCESSORIES ....................................2SCHEMATIC DIAGRAM ............................................11
CONTROLS .................................................................3EXPLODED VIEW .....................................................15
DISASSEMBLY FOR REPAIR.....................................4PARTS LIST...............................................................17
CIRCUIT DESCRIPTION .............................................5
Accessories
AC adapter (1) *Batteries : NB150 (1)Carrying case (1)Stereo headphone (1) *
(W09-)(W09-1267-05)(W01-0938-05)(W01-0963-05)
Remotcon (1)Stereo headphone (1) *
(A70-1258-05)(W01-)
* Refer to parts list on page 17.
CautionTroubleshooting
SymptomCauseRemedy
Beware of condensationUnit fails to �The disc holder is not securely�Close disc holder securely.
turn ON.closed.
�The battery is depleted.�Charge the battery.
When water vapor comes into contact with the surface of cold materi-�HOLD status is engaged.�Deactivate HOLD status.
al, water drops are produced.There is no �The volume is at minimum�Increase the volume.
If condensation occurs, correct operation may not be possible, or thesound.level.
�The remote control or head-�Insert plug securely.
unit may not function correctly.
phones are disconnected.
This is not a malfunction, however, and the unit should be dried.�HOLD status is engaged.�Deactivate HOLD status.
The unit does
(To do this, turn the POWER switch ON and leave the unit as it is fornot respond�The battery is depleted.�Charge the battery.
several hours.)to key opera- �The remote control or head-�Insert plug securely.
tion.phone plug is not securely in-
serted.
Be especially careful in the following conditions:�The disc holder is not securely�Close disc holder securely.
Y When the unit is brought from a cold place to warm place, and there isclosed.
a large temperature difference.Sound skips. �The disc is scratched or dam-�Replace the MD.
aged or the recording is not
Y When a heater starts operating.
good.
Y When the unit is brought from an air-conditioned place to a place of�The unit is in a place where�Move the unit to a place
high temperature with high humidity.there is excessive vibration.where there is little vibra-
tion or set to OPS off�.
Y When there is a large difference between the internal temperature of
Battery does �You are using commercial re-�Use the special recharge-
the unit and the ambient temperature, or in conditions where conden-
not charge.chargeable battery.able battery (NB-150)
sation occurs easily.�The unit has become hot be-�Wait until the unit has
cause of exposure to directcooled to normal tempera-
sunlight etc.ture.
�You are using another AC�Use the accessory AC
adaptor than the accessoryadaptor.
adaptor.
�The AC adaptors has become�Connect the AC adaptor
Resetting the unitdisconnected.securely.
This system uses a microcomputer so it may malfunction due to external
Meaning of display messages
noise or interference. In such a case, unplug the power cord and remove the
batteries, then plug the power cord again and insert the batteries again.MessageMeaningAction
OnoDISC��There is no MD in the unit.�Insert a MD into the unit.
OBLANK ��Nothing is recorded on this �Replace the disc with a
MD.prerecorded MD when
playing it back.
OERROR ��The *UTOC contents are �Replace the MD.
faulty.
�The disc is scratched or dam- �Replace the MD.
aged, so playback is not pos-
sible.
*UTOC: A recordable MD has an area for recording so-called UTOC
(User's Table of Contents) data. The UTOC contains number
2of tracks, playing time, written data, and other rewritable
information. |
ACEC
