FrameMaker Ver.5.5(PC) CF910 SWITCHES ON PWBs, SERVICE MODE
98.06.22
s
Setting Mode Menu RD Mode
Touch Panel DisplaySetting (the default sHetightinlighg isted )
DT setting--------------------------------------------------------
Used to perform the initial transmission from the PPC to the Center to
Initial
check for correct communication when the Data Terminal has been
Transmission
set up.
Data Save/Load Enables the transmission of Data Save and Data Load.
Data SaveTransmits the command that saves the PPC RAM data to the Center.
Data LoadTransmits the command that loads the data sent by Data Save back
to the PPC.
Used by the Tech. Rep. to notify the Center that his/her service job for
Call Completion
the copier has been completed.
Spare Counter
Used to clear the count of the spare counter set by the Center.
Clear
Marketing AreaSelect the marketing area which determines the paper size and fixed
zoom ratio settings.
MJMCMH
Manual Paper Use this function to automatically adjust the paper reference position
Widthof the Multi Bypass Table.
<Adjusting Procedure>
1. Select ?Maximum Size,? place several sheets of A ´ 3 Wide or 12?
18? paper on the Multi Bypass Table, and press the Start key.
2. Select ?Minimum Size,? place several sheets of B5 lengthwise or
5-1/2?´ 8-1/2? lengthwise paper on the Multi Bypass Table, and
press the Start key.
Org. DetectSelect ?Set? when the optional Original Size Detecting Sensors are
Sensorinstalled.
Set (When sensors are Unset(When sensors are
installed)not installed)
Serial # InputEnter the serial number of each system component including options
from the 10-Key Pad.
S-24
ACEC
