SCHEMATIC DIAGRAM
IMPORTANT SAFETY NOTICE
The component identified by shading or international symbol l on the following schematic diagrams incorporate special
features important for protection from X-Radiation, fire and electrical shock hazards. When servicing it is essential that
only manufacturer's specified parts be used for those critical components.
NOTES:
1. RESISTOR
All resistors are carbon 1/4W resistor, unless otherwise noted by the following marks.
Unit of resistance is ohm (1 ), (K=1,000, M=1,000,000)
: Non: Solid
: Metal Oxide: Metal (Precision and high stability)
: Wire Wound: Thermistor
: Fusible: Positive coefficient Thermistor
: Flame Proof Rectangular
2. CAPACITOR
All capacitors are ceramic 50V capacitor, unless otherwise noted by the following marks.
Unit of capacitance is uF, unless otherwise noted.
+-
: ElectrolyticM: Polyester
T:Tantalumm: Metalized Polyester
NP:Bipolar: Polypropylene
S:Polystyrene: Mica
: Temperature Compensation: Ceramic
: Ceramic (SL)
3. COIL
Unit of inductance is uH, unless otherwise noted.
4. VOLTAGE MEASUREMENT
Voltage is measured by a digital meter receiving normal signal.
5.This schematic diagram is the letest at the time of printing and is subject to change without notice.
SERVICE NOTES:
This model has a section that does not share a common ground with the power supply section. The different sections are
referred to as the HOT section and the COLD section in the precautions below.
1. DO not touch the HOT section and the COLD section at the same time. You may receive an electric shock.
2. Do not short the HOT section to the COLD section. This could blow the fuse or damage parts.
3. Never measure the HOT section and the COLD section at the same time when using tools such as oscilloscopes or
multimeters.
4. Always unplug the unit before beginning any operation such as removing the chassis.
� 38 � |