6557-03N/03S/43N/43S
POWER SAVING FUNCTION
This monitor meets the power-saving guidelines set byNote
VESA and Energy Star, as well as the more stringentIf no video signal is input to the monitor, the ONO INPUT
NUTEK .SIGNAL� message (page 18) appears. After the delay time has
If the monitor is connected to a computer or videopassed, the power saving function automatically puts the
monitor into the active-off mode and the u indicator lights up
graphics board that is VESA DPMS (Display Power
orange. Once the horizontal and vertical sync signals are
Management Signaling) compliant, the monitor will
detected, the monitor automatically resumes its normal operation
automatically reduce power consumption in three stages
mode.
as shown below.
You can set the delay time before the monitor enters the
power saving mode using the OSD. Set the time according
to OSetting the power saving delay time� on page 15.
Power consumptionScreenHorizontalVerticalPowerRecovery timeu indicator
modesync signalsync signalconsumption
1Normal operationactivepresentpresentL 130 WNGreen
2Standby (1st mode)blankabsentpresentL 80 WApprox. 3 sec.Green and orange
alternate
3Suspend (2nd mode)blankpresentabsentL 15 WApprox. 3 sec.Green and orange
alternate
4Active-off (3rd mode)blankabsentabsentL 5 WApprox. 15 sec. max.Orange
5Power-offNNN0 WNOff
DIAGNOSIS
FailurePower LED
+B failureOrange ?Off
(0.5 sec)(0.5 sec)
Horizontal / Vertical DeflectionOrange ?Off
failure, Thermal protector(1.5 sec)(0.5 sec)
ABL protectorOrange ?Off
(0.5 sec)(1.5 sec)
HV failureOrange ?Off?Orange ?Off
(0.25 sec)(0.5 sec)(0.25 sec)(1.25 sec)
Aging / Self TestOrange ?Off?Green ?Off
(0.5 sec)(0.5 sec)(0.5 sec)(0.5 sec)
Aging Mode (Video Aging) : During Power Save, press OMENU� key for longer than 2 second.
Self Test (OSD Color Bar) : During Power Save, press OCONTRAST� + (/) key for longer than 2 second.
Reliability Check Mode: During Power Save, press OCONTRAST�� (?) key for longer than 2 second.
� 3 � |