6558-03N/03S/43N/43S
POWER SAVING FUNCTION
This monitor meets the power-saving guidelines set byNote
VESA and Energy Star, as well as the more stringentIf no video signal is input to the monitor, the ONO INPUT
NUTEK .SIGNAL� message (page 16) appears. After the delay time has
If the monitor is connected to a computer or video graphicspassed, the power saving function automatically puts the monitor
board that is VESA DPMS (Display Power Managementinto the active-off mode and the u indicator lights up orange. Once
Signaling) compliant, the monitor will automatically reducethe horizontal and vertical sync signals are detected, the monitor
automatically resumes its normal operation mode.
power consumption in three stages as shown below.
You can set the delay time before the monitor enters the
power saving mode using the OSD. Set the time according
to OSetting the power saving delay time� on page 13.
Power consumptionScreenHorizontalVerticalPowerRecovery timeu indicator
modesync signalsync signalconsumption
1Normal operationactivepresentpresentL 160 WNGreen
2Standby (1st mode)blankabsentpresentL 100 WApprox. 3 sec.Green and orange
alternate
3Suspend (2nd mode)blankpresentabsentL 15 WApprox. 3 sec.Green and orange
alternate
4Active-off (3rd mode)blankabsentabsent< 5 WApprox. 10 sec.Orange
5Power-offNNN0 WNOff
DIAGNOSIS
FailrePower LED
+B failureOrange ?Off
(0.5 sec)(0.5 sec)
Horizontal / Vertical DeflectionOrange ?Off
failure, Thermal protector(1.5 sec)(0.5 sec)
ABL protectorOrange ?Off
(0.5 sec)(1.5 sec)
HV failureOrange ?Off?Orange ?Off
(0.25 sec)(0.5 sec)(0.25 sec)(1.25 sec)
Aging / Self TestOrange ?Off?Green ?Off
(0.5 sec)(0.5 sec)(0.5 sec)(0.5 sec)
Aging Mode (Video Aging) : During Power Save, press OMENU� key for longer than 2 second.
Self Test (OSD Color Bar) : During Power Save, press OCONTRAST� + (/) key for longer than 2 second.
Reliability Check Mode: During Power Save, press OCONTRAST� � (?) key for longer than 2 second.
� 3 � |