1 SPECIFICATIONS
Amplifier Section
Output Power .... 50 + 50 watts RMS (0.9 % THD, 1 kHz, 8 ohms)Voltage Conversion
Total Harmonic Distortion.................... 0.05 % (at 45 watts,1 kHz)(General export models only)
Input Sensitivity/Impedance .................. PHONO: 4 mV/22 kohms
LINE: 270 mV/20 kohms
Frequency Response.................... PHONO: 20 Hz�20 kHz, +/�3 dB
LINE: 20 Hz�30 kHz, +1/�3 dB
Signal-to-Noise Ratio.............................................. PHONO: 60 dB
LINE: 68 dB
Tone Control .......................................... BASS: +/�9 dB at 100 Hz
TREBLE: +/�7 dB at 10 kHz
Loudness Control (Volume at �40 dB Position)..............................
+7 dB at 100 Hz, +5 dB at 10 kHz
FM Tuner Section
(Without notes 98.1 MHz, 65 dBf)Be sure to remove the power cord from the AC outlet before
Tuning Range .................... 87.5 MHz�108.0 MHz (100 kHz steps)repositioning the voltage converter switch.
Usable Sensitivity (IHF)............................................ Mono: 20 dBf
50 dB Quieting Sensitivity................ Mono: 39 dBf, Stereo: 46 dBf1. Locate the voltage selector on the rear panel.
Capture Ratio ...................................................................... 2.8 dB2. Using a flat-bladed screwdriver, set to the appropriate
Image Rejection Ratio .......................................................... 20 dB230V or 120V position according to your area.
AM Suppresion Ratio............................................................ 48 dB
Harmonic Distortion (1 kHz).............. Mono: 0.4 %, Stereo: 0.5 %
Frequency Response................................ 30 Hz�15 kHz, +2/�3 dBIN NORTH AMERICA USE ONLY ON 120 V SUPPLY.
Stereo Separation (1 kHz) .................................................... 35 dB
Signal-to-Noise Ratio ........................ Mono: 57 dB, Stereo: 55 dB
AM Tuner Section
Tuning Range.......................... 520 kHz�1,720 kHz (10 kHz steps)
Usable Sensitivity ............................................................ 55 dB/m
Total Harmonic Distortion .................................... 1 % at 85 dB/m
Signal-to-Noise Ratio............................................................ 48 dB
General
Power Requirements.................................. 120 V/230 V, 50-60 Hz
Power Consumption............................................................ 120 W
AC Outlet .......................... Unswitched x 1, 100 W max (1 A max)
Dimensions (W x H x D) ........................ 17-1/8" x 5-1/8" x 12-5/8"
(435 x 130 x 320 mm)
Weight (net) .................................................. 15-7/16 lbs (7.0 kg)
Standard Accessories .................................. AM Loop Antenna x 1
FM �T� Type Antenna x 1
� Design and specifications are subject to change without notice.
? 2? |