PROGRAMMING CHANNEL MEMORY
The channel memory is the list of TV channel numbers your TV will stop on when you press the CHANNEL s or t button.
First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area automatically.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels.
Note: If you utilize both ANT-1 and ANT-2 terminals for some model, perform programming channels for each input source.
TV/CABLE functionADD/ERASE function
1Press MENU, then press S or T until the SET UP menuAfter performing the CH PROGRAM function, you can add
appears.or erase specific channels.
2Press t (or s) until OTV/CABLE� is highlighted.1Select the channel you want to erase using the CHANNELGENERAL ADJUSTMENTS
s or t button, or select the channel you want to add using
3Press : or ; to highlight either OTV� or OCABLE�, whicheverthe Channel Number buttons.
you use.
2Press MENU, then press S or T until the SET UP menu
appears.
CH PROGRAM function
3Press t (or s) until OADD/ERASE� is highlighted.
1Select OCH PROGRAM� following steps 1 and 2 above.
4Press S or T :
2Press : or ; to start channel programming.To erase the channel
The TV will automatically cycle through all the TV or CABLEPress the button until OErase� is highlighted.
channels selected by the TV/CABLE function, and store
active channels in the channel memory.To add the channel
Press the button until OAdd� is highlighted.SPECIFIC INFORMATIONS
3When channel programming is complete, you will see the
message to the right.5Repeat steps 1 to 4 for other channels.
4Press CHANNEL s or t to make sure the channel pro-You have now completed the channel programming.
gramming has been done properly.
Note: The CHANNEL t/s buttons on the TV function as
the t/s buttons while a menu is on the screen.
Please refer to owner's manual in detail.
� 17 � |
ACEC
