USEROS GUIDE ANALOG
To set time For watch with a date display For watch with a screwlock crown
1) Pull the crown out when the second hand at 12 oOclock positionTo Set TimeTo Set Time
and the second hand stops.1) Pull the crown out to the second click when the second hand1) Pull the crown out when the second click when the second
2) Set the hands by turning the crown.is at the 12 oOclock position and the second hand stops.hand is at the 12 oOclock position and the second hand stops.
3) In accordance with a time signal, push the crown in.2) Turn the hands clockwise and put the watch four or five2) Turn the hands clockwise and put the watch four or five
minutes forward. Then back them out .minutes forward. Then back them out .
3) In accordance with a time signal, push the crown in.3) Push the crown in to the normal position on a time signal.
To Set DateTo Set Day-date
Crown1) Pull the crown out to the first click.1) Pull the crown out to the first click.
2) Set the day by turning the crown clockwise.2) Set the hands by turning the crown clockwise.
3) Push the crown in to the nomal position.Set the date by turning the crown counterclockwise.
Check whether the day is English or Spanish.
Crown (Normal position)3) Push the crown in to the nomal position.
First click Note:Avoid setting the day-date between 10:00 p.m. and 6:30 a.m.
(Setting date) (the day-date display may not change in the following day).
30Crown (Normal position)[Day display]
First clickEnglishSpanish
Second click (Setting day-date)
(Setting time)SUNDOM
SUN30MONLUN
The configuration of your watch may differSecond clickTUEMAR
somewhat from that shown in the illustration (Setting time)WEDMIE
THUJUE
The configuration of your watchFRIVIE
SATSAB
may differ somewhat from that
shown in the illustration
For watch with a backlight For watch with the elapsed time bezel For watch with a screwlock crown
About the backlightRotate the elapsed time bezel to align the mark with theAbout the screwlock crown
" Hold down L to illuminate the face of the watch.minute hand." Some water resistant models are equipped with a screwlock
" With Modules 1319 and 2312, pressing L illuminates theAfter certain amount of time elapsed, read the graduation on thecrown.
display for about two or three seconds.elapsed time bezel which the minute hand points to." With such models, you must unscrew the crown in the direction
" With Modules 2342 and 2343, pressing L illuminates theThe elapsed time is indicated.noted in the illustration to loosen it before you can pull it out. Do
display for about one second.not pull too forcibly on such crowns.
" The backlight of this watch employs an electroluminescent (EL)" Also note that such watches are not water resistant while their
light, which loses its illuminating power after very long term use.crowns are loosened. Be sure to screw the crowns back in as
" Frequent use of the backlight shortens the battery life.10far as they will go after making any setting.
50
" Leaving the backlight on for a long time or turning on theElapsed
backlight while battery power is low can cause the hands of the20time bezel
40
watch to stop momentarily.30
Crown
Crown and
L (Light button)
L (Light button)
Crown |
ACEC
