TECHNICAL SPECIFICATIONSELECTRICAL REQUIREMENTS
Any electrical work required to install this
When wiring the plug, ensure that all strands of wire
appliance should be carried out by a qualified
are sercurely retained in each terminal. Do not
electrician or competent person.forget to tighten the mains lead clamp on the plug. If
DIMENSIONSyour electricity supply point has only two pin socket
Before switching on, make sure the electricity
outlets, or if you are in doubt, consult a qualified
supply voltage is the same as that indicated
Height165.9 cmelectrician.
on the appliance rating plate.
Width49.5 cm
The flexible mains lead is supplied connected to a
Depth60 cmB.S. 1363 fused plug having a fuse of 13 ampShould the mains lead ever require replacement, it is
capacity.essential that this operation be carried out by a
POWER SUPPLY VOLTAGE AND FREQUENCY220-240 V / 50 HzShould this plug not fit the socket outlets in yourqualified electrician and should only be replaced with
2
home, it should be cut off and replaced with aa flexible cord of the same size i.e. 0.75 mm
TOTAL POWER ABSORBED150 W
suitable plug, following the procedure outlined below
AVERAGE DAILY UNITS ELECTRICITY *1.31 kWhAfter replacement of a fuse in the plug, the fuse
WARNING:cover must be retitted. If the fuse cover is lost, the
GROSS CAPACITY
plug must not be used until a replacement cover is
Such a plug cannot be used for any other appliance
obtained. The colour of the correct replacement fuse
Fridge149 land should therefore be properly disposed of and not
cover is that of the coloured insert in the base ot the
left where children might find it and plug it into a
Freezer104 lplug or the colour that is embossed in words in the
supply socket - with the obvious consequent danger.
base of the fuse recess or elsewhere on the plug.
NET CAPACITY
Always state this colour when ordering a
Fridge 145 lN.B. We recommend the use of good quality plugsreplacement fuse cover.
and wall sockets that can be switched off when the
Freezer85 l
machine is not in use.
Only 13amp replacement fuses which are ASTA
approved to B.S. 1362 should be fitted.
STAR RATINGIMPORTANT: The wires in the mains lead fitted to
this appliance are coloured in accordance with the
Note: Socket outlets are not permitted in bathrooms,
following code.
neither should any provision be made for connecting
moveable electrical appliances. No stationary
* This figure is based on standard test results in accordance with European Standard EN 153. GREEN AND YELLOWEARTHappliance is to be installed within reach of a person
using bath or shower.
Actual consumption will depend on how the appliance is used and where it is located.
BLUENEUTRAL
BROWNLIVE
This appliance complies with the E.E.C. Directive
As the colours of the wires in the mains lead of this
No. 87/308 of 2.6.87 relative to radio interference
appliance may not correspond with the coloured
suppression.
markings identifying the terminals in your plug,
proceed as follows:This appliance complies with the following
E.E.C. Directives:
The wire which is coloured green and yellow must be
connected to the terminal in the plug which is- 73/23 EEC of 19.2.73 (Low Voltage Directive)
marked with the letter E or by the earth symboland subsequent modifications;
or coloured green or green and yellow.
- 89/336 EEC of 3.5.89 (Electromagnetic
The wire which is coloured blue must be connectedCompatibility Directive) and subsequent
to the terminal which is marked with the letter N ormodifications.
coloured black.
The wire which is coloured brown must be
GREEN & YELLOW
connected to the terminal which is marked with the13 AMP. FUSE
letter L or coloured red.
WARNING - THIS APPLIANCE
13 AMP
MUST BE EARTHED
BROWN
BLUE
CORD CLAMP
16D2075 |
ACEC
