SAFETY PRECAUTIONS
If not used properly this Gardenvac can be dangerous.
The warnings and safety instructions must be followed to ensure reasonable safety
and efficiency in using this product. The operator is responsible for following the
warnings and instructions in this manual and on the product.
Explanation of Symbols on the GardenvacGeneral
1. Never allow children or people unfamiliar
with these instructions to use the Gardenvac.
Local regulations may restrict the age of the
operator.
Warning 2. Only use the Gardenvac in the manner and
for the functions described in these
instructions.
3. Never operate the Gardenvac when you are
Read the user instructionstired, ill or under the influence of alcohol,
carefully to make sure youdrugs or medicine.
understand all the controls and4. The operator or user is responsible for
what they do. accidents or hazards occurring to other
people or their property.
Electrical
1. The use of a Residual Current Device (R.C.D.)
Do not operate in the rain or leavewith a tripping current of not more than 30mA
the Gardenvac outdoors whileis recommended. Even with a R.C.D. installed
raining. 100% safety cannot be guaranteed and safe
working practice must be followed at all times.
Check your R.C.D. every time you use it.
BEFORE USING YOUR GARDENVAC FOR2. Before use, examine cable for damage, replace
THE FIRST TIMEit if there are signs of damage or ageing.
3. Do not use the Gardenvac if the electric
cables are damaged or worn.
Assemble debris bag to bag4. Immediately disconnect from the mains
frame.electricity supply if the cable is cut, or the
insulation is damaged. Do not touch the
electric cable until electrical the supply has
been disconnected. Do not repair a cut or
EVERY TIME YOU USE YOUR GARDENVACdamaged cable. Replace it with a new one.
5. Your electric cable must be uncoiled, coiled
Switch off and disconnect from thecables can overheat and reduce the
mains electricity BEFOREsupply efficiency of the Gardenvac.
6. Do not pull cable around sharp objects.
fitting cutting line to cutting head &7. Always switch off at the mains before
clipping into place BEFOREand disconnecting any plug, cable connector or
REMOVING cutting line.
extension cable.
8. Switch off, remove plug from mains and
examine electric supply cable for damage or
Switch off and disconnect from theageing before winding cable for storage. Do
mains electricity BEFOREsupply not repair a damaged cable, replace it with a
2FITTING fully assembled debris
bag to product BEFOREand new one. Use only Flymo replacement cable.
9. Always wind cable carefully, avoiding
REMOVING fully assembledkinking.
debris bag from product.10. Never carry the product by the cable.
NEVER CONNECT THE11. Never pull on the cable to disconnect any of
PRODUCT TO THE MAINS
ELECTRICITY SUPPLY UNTILthe plugs.
112. Use only on AC mains supply voltage shown
THE FULLY ASSEMBLEDon the product rating label.
DEBRIS BAG IS FITTED13. Our products are double insulated to
CORRECTLY
EN60335. Under no circumstance should an
earth be connected to any part of the
product.
ENGLISH - 1 |
ACEC
