SAFETY INSTRUCTIONS
CUTTING BLADESAbrasive discs
The cutting material on abrasive discs consists of grit bonded
using an organic binder. �Reinforced blades� are made up of a
fabric or fibre base that prevents total breakage at maximum
working speed if the blade should be cracked or damaged. (The
term reinforced does not refer to those cutting blades that are
only reinforced around the flange).
A cutting bladeOs performance is determined by the type and
size of abrasive corn, and the type and hardness of the bonding
agent.
Characteristics that give the blade a shorter service life and
greater cutting capacity are said to make the blade �softer�. A
blade with a longer service life and slower cutting capacity is a
blade with a �harder� effect.
High quality cutting blades are normally more economical.
Lower quality cutting blades usually have an inferior cutting
capacity and shorter service life, which results in higher cost per
processed material.
General
Cutting blades are available in two basic designs; abrasive
discs and diamond blades. Only abrasive discs and diamondABRASIVE DISCS, TYPES AND USES
blades may be used and only within their respective application
areas.Use
WARNING!BladeGeneralMaterialWater cooling
A cutting blade may burst and cause injury totypecharacteristics
!the operator.
Con-UniversalConcrete,Can be used to
creteusage,asphalt,reduce dust.
High speed portable toolseconomical.stone,The disc should
Our cutting blades are manufactured for high-speed, portablebrickwork,not be stored
power cutters. If blades from other manufacturers are used,cast iron,after cutting is
ensure that the blades conform to all regulations and demandsaluminium,complete as
that concern this type of power cutter.copper,water affects the
brass, cables,strength of the
rubber, etc.disc while
stored.WARNING!
Never use a cutting blade at a lower speed
!rating than that of the power cutter.
MetalUnbeatable forSteel, steelNOTSpecial blades
Some cutting blades are designed for stationary equipment and
steel (notalloys andrecommended.
suitable forother hardfor use with attachments.Such cutting blades must not be used
on portable power cutters.
concrete, etc.)metals.
WARNING!
Never use a cutting blade for any other
!purpose than that it was intended for.
Always contact local authorities and make sure you are
following applicable directives.
10 � English |
ACEC
