LUBRICATION
3. Engine Oil
Changing the Engine Oil
The engine oil shall be changed for the Ţrst
time after 50 hours of operation. Thereafter, it
should be changed every 150 hours.
WARNING!IMPORTANT INFORMATION
The engine and the exhaust
system, become very hot Used engine oil is a health hazard and
must not be disposed of on the ground or
during operation.in nature; it should always be disposed
Risk for burns if touched.of at a workshop or appropriate disposal
Allow engine and exhaust location.
sytem to cool at least two (2) Avoid skin contact; wash with soap and
minutes.water in case of spills.
1. Place the machine on a �at surface.
2. Place a container under the engine drain
plug.
3. Remove the dipstick and open the drain
plug.
4. Allow the oil to run out into the container.
5. Install and tighten the oil drain plug.
6. Replace the oil Ţlter if necessary.
7. Fill with new engine oil in accordance
with Checking the Oil Level.
8. Start the engine. Run it for a few BAM-22
seconds. Stop and re-check the oil level.Oil drain plug
Checking the Oil Level
Check the oil level in the engine when the
machine is standing level and the engine is
stopped.
Remove the dipstick, wipe it clean, and then
replace it.
Take the dipstick out again and read the oil
level.
BAM-23
Remove the dipstick
English-57 |
ACEC
